Search results

wonder if it draws more amps when you feed it less voltage

I ran across 3 sites searching for stock that had mention of 2s,3s,4s on the immersion tx. The f450 runs on 4s and comes in just under 4 lbs as it is http://www.studiosport.fr/emetteur-600mw-immersionrc-p-453.html there in stock there I've been flopping back and forth between 3s and 4s since...

they flew nice, not alot of bite to them and they were really hard to balance. on 3s with any weight was about a wash with the 10x6, think i was 3lbs, 11oz, barely went up in atti, couldn't stop it on the way down. 4s they acted pretty decent except ran at a higher rpm overall and moved the...

The fronts had to be drilled out to fit over the 8mm hub but the back sides went on fine. The trick was to not drill into the back from the front and to leave what they call the (precision hole) in tact. The flat spot isn't needed, just make sure to tighten em down and dont over tighten them...

the positive and negative always have a different something about em to keep from hitting them backwards. dc in reverse = bad What props you curious about, i've had em all on the dji

Thanks for that youtube link, i'm gonna order up the supplies and give it a go, need a few so any savings will help

those guys make me want to go back to school

Whats the gain at? I run around 130-140

heres what hes talking about. i haven't played with it enough to have an answer for ya http://www.readymaderc.com/store/index.php?main_page=index&cPath=11_45_49

http://www.multirotorforums.com/album.php?albumid=55

so you got that working? Do you know if it's safe to run this thing on straight 4s? it says 16v, i start at 16.8 then goes down to 16 pretty quick and down from there

are suppose to be at dealers in the next couple weeks, bout time. Suppose to be the same exact thing but smaller, still airwave so fatshark 5.8 compatible

good people, great service

All the discount spots suck like this. hobbypartz has gens ace, there a little better but if you have a problem, it's a headache after another. the alternative is to buck up and order brand name. problem i've had with that is so few people do that the inventory is usually junk when you get it...

if no notification, login to your account there, hit order history and it'll say whats up. to get CS there, use there chat line, at least somebodies there. I order 6 40c 4s turnigy batteries 2 weeks ago and they were here a weeke ago, same warehouse.

micro hairballs, i hit that bearing with dikes on an angle and the crap flew everywhere, this was all i could find. small

try some of the lower grade, see how they go. I can't believe how small them balls are in these bearings. like a small mechanical pencil lead width around. Crazy little. I think going anything past what i used would be way overkillin it. these are super smooth but i'm not much of a crasher so...

awesome

is there grease in there? Definately not packed like a wheel. BTW, the 4035-400 i burned up was running a governed 10,000 rpm, in scale heli rated for 3500 watts and never got over 1200 watts I've got a suppo in a 3d plank i've tried to kill 20+ times. Break props left and right, replaced the...

just looking at it from a normal guy point of view, if you had 16.8 volt 4s and you had a 950kv motor, full throttle is 15,960 rpm...... with a what do you call it, axil radial load with single row bearings. The only stuff i've been around brushless is scorpion and next to every motor from 300kv...