Search results

I don't use the dr, but am using expo, and a ton of it. think last i looked was 60%. only way i could fly the thing manual NAZA uses gear by default. in my radio under the main setup screen where you make a model had device settings, in there i can make whatever switch move whatever channel...

ah, for some reason i was thinking the orange black became the rca, but i see how your saying In 5.8 theres only a few that have that channel range to work with fatshark, uses different channels, something about the board they use. no rx's or tx's at hobby king are compatible in stock, that was...

I finally hooked up a lead to x1 and put em on a gyro sens switch. in gyro sens, it gives me 3 settings. i enabled it, set all the gains to 130-130-130-100 and 80-80 in the lowest setting, then incrimentaly made it go up in all ail,ele boxes. was just doing it with atti, but just added the...

not like they never need oiling sealed, they have a metal dust guard on em, about it. sealed like your talking usually have a rubber dust cap, and even then i oil everything on all of em,,,, all except them orange bocas To check a motors bearings, an easy way is to hold the leg under a motor...

that's weird how you don't even hear a real change, just leans over you tried to correct and it's in the dirt. Make sure you didn't ding the prop adapters and the bearings in the motors. The gopro footage was excellent, love that tree house, looks like disneyland

there not even on the immersion site anymore, did they stop making them? http://www.immersionrc.com/products.htm

did you see this part? Thats the reverse wires i was talking about on the upper left

bolt will defeat the tape, if your worried, use a velcro strap around the hoof. I put some shoe goo on my frame and used the supplied double side on the gopro hoof, no sign of failure and it's been 80 It's most likely a prop outta balance making that motor warm. oil the bearings too.

i just looked at the manual for that tx, whats the deal with page 2 and how it has you reverse two wires? is yours the right orientation for the camera you have? My first thought was to go check and see if they had the same channels as fatshark, there hard to find compatible tx's but it doesn't...

the only possible way to get to 70 degrees is a crash in atti, no?

it has zeal tape http://www.heliproz.com/prodinfo.asp?number=138006

not bad, that zeal is the ticket. keep a good eye on it and it's adhesion, especialy in the summer when it gets hot. if it looks like it might fall off, it probably will. but for noise/jello, its the ticket one motor stands out, think the prop on one is making the bearings rattle just a hair...

download that gopro cinema software and update the firmware. those pesky weird recordings

ouch,,,,,,,

billy, i'm pretty sure your missunderstanding something you read. i never saw anything about it, haven't seen it. i like mailman have had the thing all over the place in my hand in both immediate and the other and it's never shut off unless a. i shut the throttle all the way down in immediate or...

awesome, welcome. theres a few of us here from so cal.....

are those colored ones able to be 8mm bore? the apc can, but have to be drilled. the precision hole is the right side to slide on, but that skinny stuff near the front has to all come out. I ask cause i got 12 sitting here like those that the outside of the hub is 10mm, wouldn't dream of trying...

got any onboard video?

heres the 1080p medium view, was really oscilating slow so bumped up the gains after this to 130, this was 115 atti 86

heres 4s should get going in a sec, just finishing uploading