Search results

if it hadn't been for the interferrence i was getting and how much was involved to make it right i'd of left it flying. the uhf stuff and trying to fly off has to be perfect and it wasn't. I'll get it, want it too bad

look at the ritewing motor combo...... that'd be what i'd run. alot of guys use $10 turnigy servos. I tried a set of smaller hitecs that had like 80 gram and it wasn't enough. This time i got these http://www.servocity.com/html/hs-5995tg_servo.html guess they are $120, same difference but on...

have you tried taking off the props and feeling the arms with the motors spinning propless? my guess is the prop holder part isn't perfect or the props not balanced. the stock props suck

change out that foam for ear plugs, seriously otherwise order one of them pads i showed ya, $90 but if the spacing is right and it can sit on the pad not smash into the pad, that's a lifetime part that'll last. The earplugs though are the ticket. Cheap, i used "welders" glue to put em on and...

whats the camera sitting on inside the case? can you add anything to absorb in there? You might consider a better set of motors

This is THE wing right now, but wings are pretty advanced. To start out with something easy to fly is like a skywalker (my next build) bixler, something along those lines. this thing is fast, sensitive to input and just tough to fly, like flying a naza in manual, what it reminds me of. the...

where it mounts to the bars is suppose to dampen it but obviously isn't. gopros are a cmos camera and are really tough to tame especially 1080p. 720 is easy....... the dji motors aren't the best quality looking for something smooth. is there a way to dampen under the camera or is the gopro...

I guess i missed the mark on my zeph, woud up too nose heavy. instead of tearing it apart and making something of it, i ordered another one. Things i learned on the first one, keep it light,,,,,,,, gorilla glue back all the openings you over cut, spend extra time making a useable battery tray...

that video tx has a built in switching regulator and filter......... it's part of the EZ familly one or two flight packs, but don't worry about a seperate pack for the vtx. in fact, mine was soldered right with the esc on the bottom plate.

or on earplugs like this

is anything hot?

who did you buy from? does this have gps? what all is on it? what are the gains at now?

make sure that if the throttle trim is enabled that it's centered when you do all that........ and make sure to finish the calibration in assistant with the throttle at half way exactly.

yes it is, theres a target looking thing on the bottom

pretty clear aint it. kinda tough to get turned on but once it's set your ready to roll

what all is on it? got any pics?

was just making sure you werent in thin air with the smaller motors.

after you got that trim to 0, recalibrate the radio in assistant one more time. That has to be perfectly centered when you hit finish, remember to use the switch to altitude hold before clicking finish Try bumping up everything to 120 across the top row........ atti can stay 100, but will be...

it'll smoke em unless you can prop it right. off the top of my head 6" props sound close,,,,, might need to be even smaller. overall it's a bad idea if the 5s are in good shape, go sell em at rc groups and go buy what you need

try calibration in assistant one more time. Make sure to turn everything off then reboot on a flat surface without touching it and try again. if there is throttle trim, it has to be disabled or neutral. mine can be reduced to 0% in trim settings in the radio check over your cg real good to...