Search results

with the cloverleafs on both sides, it'll be a little broken up but doable depending how clean you get the setup. a high gain patch like helical or crosshair will get you alot clearer alot further. it has to check out on the ground too. While your checking the video part, you want it all...

right, for that video to reach out 2000 feet on 5.8 it needs everything out of the way. that craft ground checked like a rock star. Your looking for good clean signal say 100 yards clear los with it on a table, sitting on that hedge, roof of a car, something like that while you tilt and spin it...

this made this that's immersion 5.8 600mw, Dis is distance in feet, left slider is speed, right is altitude. But notice how nothing gets between us. That is captured from my video receiver to a dvr, it's exactly what was fed to the monitor. if it doesn't work like that, something wrong

you wouldn't want to test it with everything laying on the ground. You would want the transmitter antenna upright. if i'm a mile out and go 2 feet, it breaks up with the 2.4...... 5.8 is more like 5 feet up or if anything gets between it and you. Oh yes, 5.8 is 5.8 and it's trademark is no...

that should have said doesn't need thicker than 14 gauge...... it's early, makin coffee still the current draw IS insignificant enough not to matter. Your looking at pieces of wire 6" long and a max current around 50-60 amps if you flew it like you stole it, hovering is 20 to 30ish amps...

if you go into your "settings" menu in the charger your gonna find something called "voltage cutoff", change that to a higher number or just dissable it. all 5 or 6 chargers i've been through the last 5 years have had it. they also have a "time cutoff" set in there usually to 1 hour, dissable...

are any of said parts still getting warm like there on? sure it's not a wire broke somewhere, things like that

hes a good guy

i tried finding some of my early recordings with this cause i used to get it alot with the right sun angle, but noticed the last 3 months or so it kinda went away. added that polarfilter thing too, not sure of that or the way the quads are shaped that i changed to made it stop. i run spider...

does latency matter? or are you just looking for framing and to "ride along" waypoints?

thats the shadow of the props

out of curiosity, why "couldn't you" use the mr?

welcome aboard, look forward to hearing more about the later where are you at? work in poway?

absolutely

i wouldn't fly it......... I've beat the crap out of em, used to run em on the bottom till i started lvc'ing in from 300' up then decided it probably should be out of the way, still all my origional cables, vu's, works One of our regulars, think plingboot had that cable short out somehow an...

it's all i've used

the esc itself is 7mm thick, the cap at the end is 10mm thick

i read on here you gotta be a certain distance out for it to turn around

it should go into failsafe and it should have more than 10% throttle when you hit it. on mine, for whatever reason was only able to get it to work in atti or atti gps but not manual unless i shift the center and endpoints to work with manual and atti. mines the futaba 8j what does yours show in...

meet ya there Chris.... flight leaves in an hour wanna make her sweat,,,,,,,