Search results

Hi Gunter , yes with the gopro and mini cameras with the video tx the ground also as to be connected. The wires coming out of the tx on the other side will be red , black , yellow , green , white ... Power to camera 12v , Ground , Video Out , Audio , Audio . I dont know what lead your using...

...

I agree Liz does do most the work :) but dont tell her that . Thanks for all the kind words for all that as nominated me so far , much appreciated .

Hi M8 if you give me a ring in the morning I will talk you through how to do it . Easier to explain on the phone , than type it all out . Geoff

If the gps is behind the IMU then its a Negative number , also the height above the Imu COG is also a negative number for the gps . Hope this helps. Geoff

i cant see a slight slant making any difference really, I have mounted antenna on top of the lid and no need to cut holes .. the cable will fit where the canopy sits over the legs . I also put copper tape on the inside of the lid and cold boot time was less than 2 mins.

There a nice radio , I have used them in my last 4 builds and some really useful features on them . I have a few in stock if you need one . Regards slider for video camera , i set them up with the dial for the camera tilt or you can use a 3 way switch with 3 levels of tilt which is easiest to...

Yep thats whats on the big fella :)

Very stable indeed , superb flying and wow the thing seems very well dialled in to me .. Good Job Ken :)

Gunter if you go for the Hobbywing Pentiums from Giantcod make sure there all from the same batch as they recently changed the chip from a atmel to silab or vice versa and this caused me a whole day of grief trying to calibrate them to start up at the same time . In the end I discovered it was...

is the arrow on the GPS facing forward ? Looks like it is facing the rear on the pics ? The arrow is supposed to point forwards . Regards failsafe set up on the DX8 , you have to first normally bind the rx to the radio , then adjust travel to make sure the bar is in Failsafe(blue) and then...

Initial Settings used were in the 130's with approx 150 on Yaw and 140 on Altitude . These are figures of memory as the cinestar is not with me at the moment. Attitude reduced to 85% but might need to play with this a bit more. Also throttle curve adjusted to give a steeper curve , Expo was...

Here is the First flight we did with the Cinestar 8 with WKM set up and Torxpower Pro Motors , swinging 14 x 4.7 apc props. It was very very windy so tuning will be further carried out on a calmer day , maybe later today or tomorrow and we are going to get the gimble set up and then test the...

Just replied to your text , You wont get motor action when plugged into the software . Also first checks with props off , and check things like motor arming , Set correct voltage as the low battery warning is too premature so need to adjust that . Check in Tx calibration that all flight modes...

Awesome Tabb , the GH2 is on my shopping list .. Have you done the Hack or is it stock ?

Problem in the UK , the mobile phone networks use 900mhz , so I do hope they can have auto take off on the 2.4ghz

More like tomorrow :)

Hi Denny , Have you done anything to the clip or is that "as is" very impressive results there. Geoff

Hi Iceman , where did you order the frame from ? And camera mount etc . Sounds like a nice set up

Looks Fab , we sell quite a few of the canopies and I think it makes the Gaui look a bit different. Geoff