Search results

Must say you have them both well dialled in there and the mounts are performing great on both machines , but yes I could see the WKM looked the less handful machine . Geoff

Very nice video , How did you get on with the set up of the Wookong M on the Octo ? What gains did you have the Wookong set to , and did you also use the futaba S-Bus with it . Geoff

Dave, Ecalc is not always accurate for me . Sometimes it is best to do trial and error .

Miles more fun with a heavy lifter :)

Thats really cool :) nice one Dave.

Dave , Geoff here .. Yes way too low them settings , You need to be in the region of 10.5 -10.6 first warning and then I usually set mine 10.2 for final warning auto descend. Also as Droider mentioned calibrate your voltage monitor, to do this just get accurate reading with voltmeter or lipo...

There was only "mild" Under the table activity going on lol.... We had a good giggle making the vids , on a serious note if we had a bigger table it would have been easier Geoff

El Magnifique Dave . And I can vouch there was no mount for the gopro , Only gaffer tape lol .

Yes the table was a little bit small :)

After a stressful few days of builds and wires , it was time to go out and play ... The sun was shining (Yes 3 days a year in the Uk it is sunny) and no wind either .. A very rare occasion in the Uk. These videos are made with a bit of light humour in them but hopefully they also show the pure...

Hi Ken , Great videos there m8 .. What were you camera gimble settings on the Wookong ?

The servo wire from the Ubec connect a Y lead to it and then remove the white signal cables from the servos and connect into the Wookong camera gimble ports , and the + and - of each servos into the Y leads . Castle creations do a good bec , with Voltage programmable from 5v to 9v I think ...

Yes gopro 2 is out and about , I like it so far, colours seem more vibrant .. Higher res pics and more shooting intervals . Also FOV can be reduced but this only seems in the 1080p mode , which still only shoots at 30fps and 60fps @ 720 .. But seems a lot better than the gopro hd , but probably...

Yes the parrots squawked a bit lol , but was a controlled experiment and no fag smoke did not get in my eye :) Its all running at full speed apart from the last bit which as been sloooooowed down to 12.5% . You should post the tree incident , it will be good for comedy value . Geoff

This is filmed using my Wookong X650 but it is actually demonstrating the strength of the 10x4.5 Carbon reinforced EPP props. Forgot to mention video shot with the Gopro Hd Hero 2, Massive improvement on colour vibrancy and better in low light .

Yes definately as i have FPV gear on mine .

The X650v Wookong on there looks familiar lol.

i have the frames coming in stock this week , probably back end or very early next week , and it came with enough plates to mount everything as you see it . I did not use there motors , and there esc's cannot be used as they are ultra pwm so will only work with there controller. 30a esc's...

Usually when this happens it is related to a motor plugged into the wrong port on the gyro or IMU , seen it happen many times on Xaircraft and Gauis .. You probably have checked everything , but it is worth checking again , and also see that nothing needs reversing . Also make sure right mixer...

You have the gimble very well dialed in there :) Great video. Geoff