Search results

What mode was that G , not had a chance to try anything here as winnnnndy again .

Your bang on the money there matey :) Geoff

Yes you need to give your hardware Id number to your dealer and they will get you a serial which will activate the view function. Hope this helps. Geoff

Very Nice Jeff , Lovely video as always and gorgeous scenery there :)

I second that :)

Xaircraft Hexa frame will not lift 3-4 kg. Max prop size you can fit is 10" and that is leaving a tiny gap between props . For the Xair Hexa frame I find it flys better with 8" and 4s lipo. Geoff

I think Dom had them default so it would be Low timing . I have advised to switch to Medium as this timing works well for me . High timing did you see a significant improvement over medium Sebas ?? as this can cause everything to run hotter.

I second what Dave said , Glad you found the problem. Geoff

Dom , everybody will have different set ups and what seems to work well etc . I have flown a Big octo CS8 with 14" slow flyers and was happy with the results and swapped to 13" apc TE on it was a slight improvement . Just completed 2 Quad Xl builds with 12 x 3.8 Carbon props on and it flies...

The flashing lights is voltage warning ..

Turn gains down even further , but when you have them too low the gps may toilet bowl . Also make sure the xyz settings are accurate.

Możesz mówić po angielsku

Looking very good for a first flight , what have you got the gains at now ? Also looks a neat build :) Geoff

As Jffry said its similar to the Mk with Jeti as only needs one output from the receiver to WKM but will still give out all the channels . And frees up the Camera gimble ports which would be used if you did not have S-BUS with a OCTO set up. Geoff

It was always a mystery to me why the original poster on here never contributed to the site but was more than happy to use it as a free advertising method .

A very nice ship there Gunter :) the lights are also very nice and bright . Looking forward to seeing it fly . Geoff

They can cut off suddenly in Lipo mode when voltage gets low , thats why most change to Ni xx mode.

I generally use default settings but have timing to Low , Battery type to Nixx , I do suppose it will depend on your motors etc but I have found low timing to work best for me . Geoff

I think Rob is just refering to general trim as he set gains on pc . I have suggested to try putting in some sub trim then re calibrating tx in the assistant software . Geoff

When they flip over this generally means you have a motor connected to the wrong motor port , On WKM Quad X config , Motor 1 is 1 oclock , M2 is 11oclock , M3 is 7 oclock, M4 is 5 oclock I think this is the same as Xaircraft anyway , But I would double check you have motors into right...