Search results

Still 3S, fully charded pack :-/

Mine is doing the same after the v2.02 upgrade. I have contacted my vendor

Funny stuff... Now mine consistently shows "low voltage" Re-installed the firmware, re-calibrated everything and still the VU flashes red non-stop for low voltage. WTF

When it prompted the update did you update the newest software, then firmware? Click on the "about" option & then "info" to see of it really updated... If it tries to update but can't based on having the prior version software on your computer then I have seen the non stop beeps occure. Guess...

Pretty sure that's where mine came from being it was drop shipped to me local (AZ)

I have only had mine for a month tops. Please let us know what you find out, I'll shoot my dealer a message to but I am a BIT behind schedule right now Yikes

After everything my Naza box has the solid red light on under the plastic case :shrug:

I have a solid red light so when get home in an hour I'll re-calibrate since I just upgraded to firmware 2.02 and see if it goes away.

I have seen this happen a few times with mine also. Under throttle red flashing... Back to a hover and it stopped. I re-calibrated and it went away. Pretty jenky so I'll have just plug in and re-calibrate often to be safe apparently

I have a rear left side dropping out intermittently as well. It happens once every 20 flights so I'm down to the following... Bullet connectors suck or Bad firmware (just updated to 2.02 for a try)

Well look at that! And the price is way better than $11 a prop... Hmmmm

Washer under the prop

I'll check all of the above and if nothin studders or cogs out with wire movement I'll solder to just be done with it. :shrug: Thanks!

Well this is my last attempt at getting such a simple machine operating after 3 weeks of sudden uncertainty. Rolled on me again, intermittently after 20+ fantastic flights. I have upgraded the firmware this morning and have replaced the rear left side motor and ESC as that was the dropping...

Yup I picked them up from gothelirc.com!

If the person who needed it doesn't post up I'll buy it from you!

Anytime!

Did you complete the whole assistant set-up with transmitter calibration as well as GPS calibration afterwards? Also gains?

I figure when I'm flying farther away the light won't do anything for me

Not sure how you guys are getting away with no spacers on the Graupners... Mine were not "confident" tight without them. :shrug: