Search results

Well it seems you have tried the majority. I say replace the plug and cross your fingers! Or you might need to put on a new bottom board to rule that out too

Try turnin off your "voltage monitoring" in assistant and / or recalibrating the voltage... Rebound the Tx and Rx already correct?

Ok so everything registers in assistant with stick movement, switch selection works, LED is working but your just not hearing the audible initialize?

I'd check the VU-BEC, not sure how to actually test that though. Can you see of the "caps" are ok?

I would complete the firmware process, re-write everything into the Naza, calibrate everything to start. Anyone local have a Naza to try out? Are your motors beeping during the initial plug in? Is the LED working on the BEC indicating the different modes. Yellow for Alt, Green for GPS of you...

Have you re-flashed the Naza? Checked the BEC? Bottom board ok?

I've ordered Graupners as well... No more DJI props for me.

Original as in they changed the length of the threads on "newer" kits?

Close

I have all the same tendancies which may have caused mine to go down also. For now I'll do a quick fix of making the bullets tighter as mentioned to see if my twitch still exists. Thanks for the info

There are 2 versions of this power supply. (The 12volt-575w & 24 volt-1000+w) I picked this up "based on price" as mentioned, & I'm not utilizing the PL6 full potetial at this time.

Here was my choice from MaxAmps because of the price.

There you go, apparently the DX6i will work! Chat with Ed, he helped me a great deal today

I was told minimum 7 channels but I can not say I know that 100% Check the PDF Naza manual if you have some time, if I was home I would take a look

I sure will DesJardinsJ

I'm going to make a Pre-set fail safe vid on how to verify your "over the 10% minimum" and get the pre-set failsafe correct. Passing it on is what I'll do for sure

I have learned a valuable lesson, I thank you! :)

Ok so I changed the first 100% value to 75% which is about 15% throttle (over the 10% minimum) Now when the Tx is turned off it still goes to the GPS/failsafe AND the throttle indicator bumps up a bit in the assistant screen

When I enter the servo menu it's 100% & 100% for throttle. So I make only the left value 10%? Or 90% which indicates minimum stick input is 10%? There isn't a negative value

I really don't know then because when I did the "pre-set" failsafe binding proceeded then tested while watching the assistant no matter what throttle position zero or around mid-stick the indicator alwasys entered failsafe when the transmitter was turned off. :shrug: I will re-do and test using...