Search results

I would

Make sure the balance board runs the JST, not TP. Are you looking to charge one pack or multiple in parallel? Also the CellPro specific boards that charge through the balance lead only are limited on charge rate so check that out too. I went for the FMA multi-port Safe parallel board (pricey...

Prop reamer like this one http://www3.towerhobbies.com/cgi-bin/WTI0001P?I=LXG941&P=8

9" requires washer and reaming out to 8mm, 10" only requires washer for spacing. Weight will dictate prop size and many seem to go 9" to help with wind. So far I'm happy with the 10"

Yes, especially when in 1080 "Wide" But I don't mind seeing the motors/proprs, it gives me something to base horizon off of

I'll wait from now on trying any update on a controller or FBL unit for at least 2 months.

Go with the Graupners & don't look back. Get the spacers also for a tight prop. I got the props & perfect spacers set from gothelirc.com

Check your bullet connectors to make sure they are very tight. Check for vibs, make sure your battery is strapped down well & check motors for movement.

I'm using the washers from Gothelirc.com also

Haven't used their flight packs but use their PowerSuppy which works great & used their packs for the mini e-Revo and no problems with those lipos

RTH feature can be done with the flip of an Assigned switch while the Tx is on & set-up as a failsafe RTH of the Tx is shut off or loses signal. GPS compass of course is needed

Available local?

Damn, sorry to see that!

Yea I'll do the washers because the locknut will still almost hit the motors 8mm shaft portion

Just fitted my Graupners & yup needs a spacer or the M6 nylon lock nuts so that clearance isn't an issue. Back to the DJI props "lightly tightened" for the low mild flying LOS for now :shrug:

I honesty am very impressed with what the Naza/GPS combo does for the price. Hard to beat it for the $

Guess I need to buy spacers for my Graupners... Somebody should just make a different set of "nuts" for the motors

Sorry to hear it went down again! I see is a LHS told you DJI fixed a problem. Is there any release from DJI that they "fixed" the props regidity? That's why everyone goes Graupner when there is load

Each will be different... Payload, camera, FPV or just ARTF for fun? Without FPV gear and a 2250mAh Pulse 45C pack I can safely fly for 9 minutes while doing line of site slow flying

Good point, mine turned CW as that was a shorter turn to face home. 90 degree turn