Recent content by toptweaks

Thank you soler for pointing out this. i am still searching the thread but maybe not find the right keyword, its okay will search more. yes have read about this long time ago but limited info's that is why ask again ...

Hello members, i am about to build a quadcopter. Was thinking of to mount the esc just below the CF motor mount. My point is to lessen the interference to the center frame which i mount the flight controller. Need your opinion guys, is it BAD to install the esc just below the motors... will...

Hello guys, could anybody share the gains setting for dji naza-m gps ... what the best gain values you have used so far ... thank you

i do it like this all 3 pieces ... 2 goes into the slot 1 mount it front outside

jckoniecki, thank you for your reply, yes, i also used naza and of course naza assistant software, i also notice the twitching ok i will try this again. setup all and recalibrate then go fly see how it goes. thank you

are you saying you recalibrating the comand sticks calibration ? just before you take a flight

hi ... ok had made changes, is this setting is okay as below, i am using 3s and sometimes make paralel connection with 2 3s lipos

if you want to cut the 4 wire, there is 2 wire with the same wire orange. make sure you mark this first to avoid mistake connection. as for me i cut and joint the wire 1 by 1 just to avoid mistake joint ....

for my f55o with naza... i use double sided tape as thin as it could be same specs as dji original 3m tape. there must be a reason for that dji supply the thin type not the foam type. foam type a bit thick and may result of the fc not that level even though see with eye its level. so the thin...

Hi, for my build, i have extend 3 wire and 4 wire so that the led can be tight at the bracket. what i do is cut the original (3 and 4) wire take another wire and solder and connect between the cut wire so that it is extend. had refer with Eric DJI techincal support and he say should not be a...

am sorry, just a quick video with not-too-good quality android camera ... had installed the naza led down at the bracket just a short video about it ....

nisouck ... sharp eye :-) not connecting it to the copter just fill in manually for the purpose of checking but will connect it to the copter and change the value and share here ... thank you all :-)

Thank you very much for advise KopterX will change this value and look how it goes ... by the way any recommended telemetry system ... a link ... thanks

i upload the pics big but it turn out small well load it from another page.. what is the best value to put it ... let says if the batt is all new ....

i am using 3s lipo 5000mah at the moment, planning to have paralel conection into my f550 hexa running with dji naza... can some one please check if the value used is correct in below picture. if not correct please suggestion for me as per explain by KopterX as below: first level protection...