jckoniecki
Member
My flamewheel 450 likes to drift to the rear when I go hand's off on the controls. I have my naza centered and flush with the included Gyro Tape.
I have checked and double checked for Center of balance and with my Go Pro and the Paint Mixer Stick method use my battery placement to adjust the COB.
I have verified that the collaboration was run successfully.
What other steps should I try. My Build/Setup
http://www.youtube.com/watch?v=pAMguHDsuwY
Thanks
JK
I have checked and double checked for Center of balance and with my Go Pro and the Paint Mixer Stick method use my battery placement to adjust the COB.
I have verified that the collaboration was run successfully.
What other steps should I try. My Build/Setup
http://www.youtube.com/watch?v=pAMguHDsuwY
Thanks
JK