Tomstoy2
Member
I'm trying to figure out how to set the failsafes on a Futaba t8fg super. Right now I got it where if I turn off the tx it goes to att mode when in gps or manual mode. It does not highlight the failsafe. What am I doing wrong, any ideas?
On my tx, this is what I have failsafe set to, guys. Please check it out and let me know if this is correct or not.
ch 1 = ail = f/s =b. f/s on = 0%
ch 2 = ele = f/s = b. f/s on = 0%
ch3 = thr = f/s = b. f/s off ( not too sure on this one, figured the f/s functions on the fc would handle this along with tx timer )
ch 4 = rud = f/s = b. f/s on = 0%
ch 5 = gear, ( flight mode 3 pos. s/w ) = b. f/s on = +100%, ( no idea )
ch 6 = vpp, ( gimbal pitch ) = b. f/s on = =100%
ch7 = aux5, ( U port on fc ) = b. f/s off ( no idea )
ch 8-12 not presently used
I've played with the endpoint adjustments, but so far, all I can seem to do is to get it to go back to att mode, not failsafe. What am I missing?
On my tx, this is what I have failsafe set to, guys. Please check it out and let me know if this is correct or not.
ch 1 = ail = f/s =b. f/s on = 0%
ch 2 = ele = f/s = b. f/s on = 0%
ch3 = thr = f/s = b. f/s off ( not too sure on this one, figured the f/s functions on the fc would handle this along with tx timer )
ch 4 = rud = f/s = b. f/s on = 0%
ch 5 = gear, ( flight mode 3 pos. s/w ) = b. f/s on = +100%, ( no idea )
ch 6 = vpp, ( gimbal pitch ) = b. f/s on = =100%
ch7 = aux5, ( U port on fc ) = b. f/s off ( no idea )
ch 8-12 not presently used
I've played with the endpoint adjustments, but so far, all I can seem to do is to get it to go back to att mode, not failsafe. What am I missing?