Can you please take a picture and post that?? I would love to use that setup. If you could can you show my me the connections from the GCU to the R617FS. And also what you did to the 7C. That would be a huge help.
Can someone please help me get the video display to work? WKM, Z15, Sony Nex7. I am pretty sure I have everything connected properly. I think I need to "toggle the HDMI" but I am really confused how to do this? I turn the camera on start recording, power on still nothing and vice versa...
Yes, I have the video input connector in (see pictures)
My camera is a Sony Nex7... I have the HDMI connector plugged into the camera also. Am I missing anything. I am not sure what to do with that Control Signal Input Port.
I am using a Sony Nex7 camera.
Ive attached some pictures to show you the way it is connected right now? Also, I have an HDMI that should connect my camera to live video feed..
Any suggestions...
I had an issue with my original circuit board for Phantom 2. So i purchased a new one, reinstalled everything, soldered everything exactly as it was before. I ran the advanced calibration, rebinded the controller, calibrated again etc. On the Assistant Software it shows all my controls...
Hello, I have a Boscam 7' Monitor w/ built in Dual 5.8Ghz Video Receiver and DJI AVL58 Tx
I read these are compatible. So when I hook everything up via DJI IOSD MARK II. The only display I am receiving on the monitor is the iOSD info and a gray screen (see pic). I have a DJI S800 Evo with...
Thank you, so after consideration, I decided to do with all DJI AVL58 TX/RX and use a 7in monitor and ditch Fatshark/Immersion. The monitor I have is a Boscam Dual 5.8ghz built in receiver. I will still use the iosd Mini for now.
Now I am confused where I will connect the 8pin from the TX I...
This might be a stupid question, but can I do the 360 degree calibration with the Z15 zenmuse powered on also? I always think its putting the gimbal in odd positions thats its fighting to resist. If someone could tell me how they do there calibration that would be awesome.
Can someone please help me get this installed properly. Here is my situation:
I own a S800 Evo, WooKong M and Z15 Zenmuse gimbal - Sony Nex7. Futaba T8FG (pilot) and 7C (camera). I want to use FatShark Attitude v2 goggles for FPV with Immersion 600mw transmitter and DJI iOSD mini. I am lost...