Totallycommitted
Member
Hi guys,
I,m looking for some help on how to connect my ubec so that I don,t have power issues using my cam gimble.
1) I,m assuming the signal wires are split off and then run through to the mc , so 2 signal wires for pitch and roll to go to f2 and f1 port and then the servo wire for the 360 ? does this get put into a separate port on the tx and assigned a separate button on the controller, so what happens to the two power cables leftover ? Do these get joined and then connect to the extra battery ?
2) the 3rd servo is for 360 so again do i assign a controller stick to an aux channel on my reciever and then split the power cable to join with the other two (pitch roll) or do i just plug signal and power to the reciever ?
thanks
Matt
I,m looking for some help on how to connect my ubec so that I don,t have power issues using my cam gimble.
1) I,m assuming the signal wires are split off and then run through to the mc , so 2 signal wires for pitch and roll to go to f2 and f1 port and then the servo wire for the 360 ? does this get put into a separate port on the tx and assigned a separate button on the controller, so what happens to the two power cables leftover ? Do these get joined and then connect to the extra battery ?
2) the 3rd servo is for 360 so again do i assign a controller stick to an aux channel on my reciever and then split the power cable to join with the other two (pitch roll) or do i just plug signal and power to the reciever ?
thanks
Matt