Search results

I put OSD mini on F450 with naza V1 with PMU, LED and version 4.02, and it worked great! Have done a rebuild for cleaner wires and component placement and now I cant get video or OSD info to work. The green light on the IOSD Mini is blinking, manual states that is "data communicating" and on is...

I want to solder a JST plug onto a F450's frame where you solder the battery cable and the VU to power a simple 200mw 5.8ghz video Tx. Will this cause any problems powering all the devices off the flight battery pack (motors/esc's/Naza/RX/Video TX ect)? I use both 3s and 4s flight packs with the...

I have a stock F450 with very bad drift to the rear right side of the craft ( about 140 degrees on a compass). I have labeled motors A B C D with A on arm 1, B on arm 2 ect. I switched all 4 motor placement, front 2 changed with back 2 but keeping each motor on the same side IE: Arm 1 is now D...

I may have a problem with my Naza imu could be software(as seen on my previos threads) I want to do a firmware update on top of current firmware IE: 2.02 over 2.02 just to be sure its working. After I do this in assistant 1.8 it tells me to cycle the controller ect but when I re power the Naza...

How close can you put your other electronics to the Naza. My F450 is currently dissembled before I rebuild im wonder if there are problems with placing Futba RX, the VU, 5.8ghz video TX or small video battery on the bottom plate around the Naza. I want to keep as much weight to the center and...

I have a stock f450 with naza and gps that will drift backward and to the right (drift is the wrong word, it flies backwards, i need about 16 trim on a 8FG for it to hold in place, it is very bad at start of flight but as the batteries run lower, the drift becomes less). I have had this craft...

I want to velcro the GPS on top of the battery to try and get the sensor as close to the Naza as possible. Anyone tried this, any foreseeable problems? Ontop of the flight pack my X Y Z axis are just 0cm 0cm -7cm. the only was to get it any closer would be to put the flight pack under the bottom...

Had a great 6min fpv flight/test and decided to let it land itself during RTH it was about 20 feet from ground and started bouncing up and down, did this 3 times. I took control back rotated it 180 deg and it stoped. Turned it back so the sun was on the left side of the Naza and it did this...

had my F450 LV cutoff set for 4s but forgot and tried to fly with a small 3s pack........ I took off, got about 30-40 meters high and was flying well then instantly second level protection kicked in. It came down like a rock with a way-to-small parachute, I was giving it full throttle but i...

I am going to get a Futaba for my F450 and soon to be F550, I will be doing long range FPV so UHF compatibility is important. Obliviously the 8FG Super is very popular. Because they are both sbus and can go to 14 channels is there any value to the extra channels on the 10CG. What are the pros...

Anyone using the Hitec Aurora 9 with the F450 or F550? I need to replace my Dx6i so im starting the research for a new 8-10 channel radio. Currently looking at the Futaba 10CG or 8FGS also. I will be flying FPV for AP and fun.

I want to do a re-build on my F450 as I did not get the NAZA completely centered/level and I do have a lot of drift. Is it possible to get replacement 3M double sided tape pads or is there a substitute?

I think I am going to try APC 8X6s on a stock Naza/GPS F450 with a 3s 20C 22mha. I am still very new to this so is this a bad idea. I dont want to use the stock props anymore as I have about 10 flights on each. Will thies props work better with 4S? any info as I am learnig. Thanks

I am looking for a good place to order a set of graupner 9x5s. They will be going on a f450 NAZA/GPS with a small FPV setup used for AP. I could have them shipped to a USA or Canadian address but cant find a set on Ebay, so where have you guys got you Graupners from?