Search results

Ok I turned the PIDs WAY down and that helped, so I just have to keep working with that, but it may also be balance. Sorry I didn’t realize earlier lol. Thanks!

Nope, I tried turning p down and d up, no substantial changes- however I will keep trying. Thanks for the advice. I’m sorry, but it won’t let me upload even a 3 second video

No, I haven’t. I just set them to default, but I didn’t think that pids could cause that bad of an oscillation. I’ll try tuning my pids and hopefully can post a video soon. Thanks!

Hi. I recently built a new racing quad and finally decided to fly it today, but it has severe oscillations(with all throttle values, the quad uncontrollably jerks around, somewhat high frequency, no pattern of occurrence) I have a 210 frame with a naze32 rev6(temporary until I figure out what is...

Dji seems like the best, most reliable, and easiest to use brand. It is evolving into something great.

Hello guys. I found a king kong 12 a esc. Apparently, it does not have bec because it has opto. What is that? And will it work? Thanks Sent from my iPad using Tapatalk

Last question: I know that a 6ch receiver must be used, but I only have a 4ch transmitter bound to it. Will it work? Thanks Sent from my iPhone using Tapatalk

Yeah, I don't want to make a huge investment. What's the diff between a regular flight controller and a micro one? Thanks

Hi guys. Is is a good setup? Thanks Sent from my iPad using Tapatalk

What will happen if I use the 140 solder? Will the esc catch on fire? And I am building a semi light 250. I will get the small banana connectors. Sent from my iPad using Tapatalk

Then would my 140 watt gun be too much? It takes like 12 minutes for the butane one to heat up. And how much weight would connectors add? Would it make the quad sluggish? Sent from my iPhone using Tapatalk

I know that the esc are 12a. Is it good to remove the middle wire? That is what a lot of people seem to do. And what is the most common size for the bullet connectors? 3.5 mm? Thanks Sent from my iPad using Tapatalk

Ok ill do it that way then. Do you know what size simonik escs are? Thanks Sent from my iPad using Tapatalk

I could get a small tip for the gun. I have a iron but it's powered by butane with a fire. I don't like it. Could I do it with bullet connectors? Or is it too hard? Thanks Sent from my iPhone using Tapatalk

Hi guys. I am wondering how I solder an esc to a motor without blowing anything up? Is it possible for me, because I'm not a pro. I only have some experience. And I have a strong solder gun, not iron. How can I do it with a regular esc? Thanks Sent from my iPhone using Tapatalk

None really did. Maybe a little? Could there be other problems ? Sent from my iPhone using Tapatalk

Ok the Naze 32 sounds really good. All of you guys seem to have no issues with it. Will it still work with a six channel receiver? And is do you require programming knowledge(besides common sense((too much))? Sent from my iPhone using Tapatalk

And I noticed that someone else on this for I had an issue with the Naze32 with temperate . Is that a common issue? The temperatures here have a huge range. Thanks Sent from my iPhone using Tapatalk

What is the difference between all these softwares? Do they do anything different or are they just a little bit different? I guess Naze32 is the winner. Sent from my iPhone using Tapatalk

Clean flight is used for Naze32 right? I know open pilot is for cc3d. And what issues does the CC3D have? Sent from my iPhone using Tapatalk