Search results

the latest hardware with simonK is hitting 600hz refresh rates http://www.altitudehobbies.com/ipeaka-iq-series-30a-brushless-multi-rotor-esc-400hz-refresh

with everything on and the ezuhf tx plugged into your usb port, in immersion tools go to Tx PPM diags and them sliders i mentioned are in tx HT PPM diags and look those over

this is a "trainer port" setting...... if you hold down the button and turn on the power it goes into system menu, roll down to trainer and you want master mode...... is that there? have you had the tx on and gone into the immersion tools? isn't there a checker there shows live feed what your...

whos your dealer? Swap left motors for right motors and fly it again, see if it still goes the same way,, if so, is esc or the flight controller. if it switches sides, it's the motor. dunno how else to figure it out. don't go so high.

i'd go with real world advice in regards to multi rotors. The story with any dji equipment is if it's not hovering at mid stick in manual, your not gonna see anything you like. but your new, and manual mode isn't very good for a new guy. usually involves a crash. but a simple fast check is to...

you should be down in size, more like 10 or 11" with those motors. your either smoking a motor or esc overloading them like that. A lite crash involves taking the prop adaters off, spin em up and feel for vibes. mount prop adapters and do the same...... then prop it, at a low speed, touch em...

awesome! love that camera

twice in 3 minutes, theres a new kloner record... dam, gotta go clean this up now With zoom like that and the altitude it is flying, the legs aren't even near the fov. That is one bad mofo.

yes, your reading it right. DIS is distance from pilot in feet....... This is with the 3db gain crosshairs in diversity and i can get about 5 miles on them. at 4 they get that pixelated look and it kinda locks in like that till about 5 it was going ape**** with static. the 10db gain starts...

was that protune? was it taken through cineform to apply the color corrections? Looks fantastic, have you tried flying it yet? Jello?

on one of these

awesome, your gonna love flying that thing when you get it all dialed in

sony as-10, thanks try to give it justa little forward then let it glide flat then pull back a little, like aerial video style and see if it still acts the same. To throw atti around is to need alot of ground and tune it way back to let it do it's thing more

these things are usually rock solid, but it take some finagling. alot has to do with overall tune, balance of props, motors, etc all play a factor. but when there dialed in and given a chance, mine carries it the same altitude within a foot or so for miles on end. my cg is back where the rear...

daves in the zephyr <br>

if your forward flying alot, move the battery back a tad and go try it again. CG is everything theres no camera?

try moving your atti gains down just a tad, say sub 100 towards 90........ if this is in short distances it's usually a cg issue. post up a picture of what you got I persoanlly have seen this as well with throttle trim active and having it move. there is a way to dissable throttle trim, it...

got my care package from ritewing, check this thing out. That ought to fly a nex-5

i did on a new build so haven't flown it yet....

it doesn't matter what order there plugged in, but if it is spinning the wrong way, swap any two motor wires, the black ones