Search results

No best not do that.. just make sure AH is on.. I dont always but I am well aware of what I am doing so it wont just go bury itself in the ground. Dave

Gary I can fly to hele B standards but not with a hele! Well until cast iron gets in the way ;-) Dave

Check the motor.. if its the BL the motor stutters Dave

With come home enabled I can interrupt the flight by using the sticks to take it somewhere else or yaw it round. as soon as you let go of the sticks she continues home Dave

Bart what firmware you running.. Geoff at QC had the same problem and so he down graded from the new firmware to the 82b.. you need my test flight table buddy.. I have found it invaluable. Dave

Think its the motor . Just soldered a replacement motor on the BL and no error.. Just another lesson eh!? Guess when you have a major incident you should just bite the bullet and do it all.. rather than trying to bandaid stuff.. Dave

Well done Ross.. dis you have to do the paperwork exam or just the flight?

So I am almost there .. I had tested everything out and run a motor test an BL temp test on my new test rig.... so I go back half hour later and I am getting a two blink red on my BL 6.. the one I swapped out this morning because of the stuttering motor.. Now does the blink say its the BL...

Like wise VERY INSPIRING... Brilliant find and a perfect example of the use of MRP for video. I wonder what his pics were like! DAve

I posted these on my gallery that are larger file size so you can see how I have soldered everything http://gallery.me.com/davehalton#100458 Dave

Love the Extra landing on the seat.. and the following recovery.. quality...

EXCELLENT... Love the flip when it worked with the thud on the table then on the ground plate.. Its just a good job as a Moderator I can't join the contest as my triple pirouette with half pike is something to see ;-) I guess you will produce something special for the final event...

As always ken.. very informative.. thanks for posting that.. Dave

Very good.. nice find Crash..

EXCELLENT.. very trusting Cub Pilot.. If I tried that down my local strip they would flip! You just line of site there... If so bloody brilliant minds eye.. Dave

Shorted.. you mean solder from another fet? or just knackard? No its a used one

OK built everything back up and got to testing motors. Had to reverse a couple in the BL control panel of the MK tool. Got everything sorted and was just going through the set up one more time to make sure everything was ok and this started happening on one of the motors.. I have tried another...

After a total rebuild taking the greatest of care I still have exactly the same fault. Grrrrr.. The MKtools must be saying something by the following In NAV control pain all status lights are green.. In FC pain NAV MAG are green BL red FC flashing red green.. This must tell you...

So.. I took everything apart had to cut up the distribution board to get all the bl's off. This is something to think about if you go for the new XL hexa distribution board. Because of the way you add the BL's its virtually impossible to remove them after soldering them up. I am also...

Crash can you post a link to one..I have begun to set up my testing rig which I will post pics of when its ready. that would be a good addition DAve