Recent content by StormRU

Any more reports of successful flights?

not a lot. props only. could be worse.... cinestar frame is rigid ..........and expensive to crash

i did one indoor test in my garage. it was ok. then i took it outside. it was windy. The ship bacame unstable and uncontrollable after 2 seconds of flight. crashed it. did 4 more tests. same results both in manual and AL modes

is there anyway i can buy a wire which connects GPS antenna to GPS board ?

it was a firmware bug with is solved in 4.3.860 i believe

hm.... i experienced this a couple of times as well. it is strange..... turnigy as well can it be something wrong with HFP firmware?

My motors and ESCs stay cool. I use 2x4500 or 2x6000. I dont know what flight times do i get. I haven't flown that much yet but I feel it is over 10 mins on an empty (no gimbal) frame. The ship airborne at 40% of the throttle

Ok, thanks! I will check it out as soon as rain stops.

Here is how i mounted mine http://www.multirotorforums.com/showthread.php?4241-Hoverfly-Pro-and-Cinestar-6-Airframe&p=49743&viewfull=1#post49743

I dont think that your instability problems are due to 14 props. How did you mount your HFP to cinestar frame?

it is ok. but i have not had a chance to shoot a video yet. because built in roll compensation was not good. (haven't tested new firmware. it is raining all day here today) I have preordered Radian and waiting for it to arrive. I have also some problems with GPS (may be a wire harness issue) +...

which camera mount do you use?

naza is worse

i have almost the same except I use Tiger Motors pancake MT4008 600kv, RCtimer 40a simonK, 2axis camera mount. You need to use 2x 5000 to get better flight times and probably more efficient motors

Naza's built in gimbal software is a nightmare. On the other hand HFP gimbal software will not give you a satisfactory result as well. You need a separate gimbal control board anyway. While in FPV flight you will hardly notice even medium shakiness of your platform.