Edit: sold!
Up for sale: a DJI Phantom FC40 with Tarot T2D gyro-stabilized gimbal and Gopro Hero 3 Black Edition action camera. Bascially, a full package.
I bought this FC40 on a whim, bought a Gopro to go with it, had a few flights, and that's that. I'm not a photographer or videographer and...
If I might ask, is there an inexpensive stabilized gimbal for a Hero 3 that would fit a Phantom FC40 that's better than the T2D? I admit I'm a bit burned by my experience and if I'm going to have to drop $40 on just a circuit board, if something's out there for the $100ish range I'd much rather...
No luck with that - I'd tried on 3.3.2 as well as 3.2.
The USB interface works when I connect it to the motor port without incident - it opens the COM port and gets voltage info for the motors. I can upgrade the firmware but it never seems to register if I disconnect and reconnect.
I even...
Already tried unplugging everything and replugging it into the correct plugs, based on the pictures shown in the manual linked above. All the plugs are inserted and aligned correctly - notch to key, key to notch.
I posted in the electronics thread but didn't really get much response.
I got a Phantom FC40 with a Tarot gimbal for a Gopro Hero 3 off a guy on Craigslist. The gimbal worked fine when he demonstrated it and then the other day when i flew it.
I don't know what happened but now when I power the...
I got a Phantom FC40 with a Tarot gimbal for a Gopro Hero 3 off a guy on Craigslist. The gimbal worked fine when he demonstrated it and then the other day when i flew it.
I don't know what happened but now when I power the gimbal on, the LED lights solid red, blinks green two or three times...
I could do the quad alone for $150 if shipping doesn't kill me. It'd be BNF, though - just the quad, the Rx currently connected, and that's that.
Edit: Sold!
-Hobbyking X550 frame and X550 landing gear/camera gimbal (Includes a servo)
-KK2.1 LCD FC board
-Hobbyking power distribution board
-Turnigy Multistar 20C ESCs
-Unknown manufacturer 900kv motors
-3 batteries, all 2200mah 11.1v 20C lipo - one is the type where it has a large black and red plug...
So I was trying to bind a receiver to a KK2.1 board, but for some reason, it went into some kind of reboot loop when I connect my battery. The LCD lights up and shows the HW/FW versions, then reboots.
When this started a week or so ago, someone suggested re-flashing the firmware. Okay, done- I...
I'm new to quads and purchased a secondhand quad, which doesn't come with a transmitter, module, or receiver. Anyone got one to sell? Not looking to spend much more than $100ish.