Hello All.
I had the original bluetooth indicator to program via iPhone. Never really used it.
Just picked up the new Datalink with BT for the IPAD. However when I go to connect it's asking for that original password I set up and I'm not sure what that password is, I have tried everything I...
No not as of yet. When I have flown that particular drone I have just been doing it then trough the Naza...
Sent from my iPhone using Tapatalk - now Free
Drew
I'm sure we could find a way =) 3D print some new legs that were taller or something. Granted I'd have to sell a kidney to pay for the Gimbal and camera.
Anyone have one of these setups?
I have H3-2D now and need some zoom functionality for closer pictures and stills.... wondering if the Nex series and the corresponding zenmuse is the way to go. Ideas\thoughts anyone?
Thanks
I checked them out, and the question is more how to take a dangling wire antenna and attach that to something. I'd have to open up the whole package to see how it's sconnected, but I'm assuming it's just a solder point on the circuit board... Big risk.
Any way to just attach that...
Okay thought I'd post my final setup.
IN this case I was pissed off and decided to go to walmart. I had read things about a specific Vizio monitor that they don't make any more so I bought the 22" Vizio (E221VA) LED monitor at Walmart. Drove to the nearest Forest preserve, plugged it into an...
Maverick
Thank you. I use that for my voltage alarm :(
I however finally found this from a company who apparently does a lot of RC ELectronics.
http://www.amazon.com/gp/product/B008P4GDX6/ref=oh_details_o00_s00_i00?ie=UTF8&psc=1
Hello All.
Per recommendations on this forum I purchased a 17 inch TVIEW Monitor that suppose to be pretty good for FPV flying.
I have two FPV Setups I have tried flying:
Original: DJI AVL58 5.8 GHZ (preferred). This one is horrible on the ground when connected to the monitor with and...
Okay.... getting my but kicked trying to find a UBEC or regulator that will allow for me to my QUAD's 6S lipo to power a Hornet OSD which requires only 12V input. Trying to avoid having to run a second battery if possible, any chance any one has a good UBEC or something they know would fit on a...