Most motors just use a round adapter like that. You won't be able to use your dji props, but they won't come loose in flight. I have used up to 20" props on electric airplanes with 2000+ watts and haven't had any issues at all. I do prefer tmotor style props for my more expensive multirotors...
Are you using the open pilot cc3d software? If so you need the find the tab for arming the motors and set what stick commands you want to use. You will need to check this every time you change setting. The software will shut off motor arming while for safety.
Sent from my iPhone using...
What batteries will you be using? I think you need to run your setup through ecalc. I think a 10" prop is going to be small for those motors. I run a 12" prop with 4s lipo on some 3508 700kv motors. (T-motor)
Also, for a gopro I would probably just use a quad setup and use the savings to...
I never tried PAL so I can't sat whether it makes a difference. I would be curious to know if that is true though. I would like to pick up another to mount in the front of my I1.
I used one for a little while. It was a pretty good camera. My only complaint with it was it took longer to adjust from light to dark when flying in and out of darker areas than some of my other board cams.
I saw a review of the metabones adapter on Sony a while back. (Having trouble locating it now). The reviewer was comparing the speed of a canon lens using the adapter to a Sony e mount lens and the speed was drastically different. I'd be curious to hear of your speed finding once you get the...
That torque screwdriver goes down to 2.5 ft lbs it looks like. One of the reviews said 25in lbs so it's kinda unclear, but either way I would look for something that went down to about 5in lbs. I think recommended torque on an m3 button head screw is more like 12in lbs.
Sent from my iPad...
That looks very nice! I have been looking at a getting an x carve or a shapeoko 3. Just haven't pulled the trigger yet.
Sent from my iPad using Tapatalk
Right-click on the Private archive, choose "Show Package Contents." Then the AVCHD archive, choose "Show Package Contents." Keep doing that until you find the STREAM folder. Drag the MTS clips out to another drive. If I remember correctly.
Sent from my iPhone using Tapatalk
I know that drone dudes were just in Detroit filming some stuff at gm for pbs. It's possible the aerial footage you saw is theirs.
Sent from my iPhone using Tapatalk