Built this quad last the winter and have had several successful flights with it.
Brought it with me on vacation to Colorado. Powered it up to re-calibrate the compass for the new location, and the HK Quanum 2D gimbal did its usual flopping around (camera wasn't installed) and suddenly the gimbal stopped moving.
Now I am unable to spin up the motors. Everything else seems to work, and I get the armed sound. Have GPS lock. Mission Planner shows it as armed with a correct map location. But, motors will not spin up. Disabled pre-arm check in MP, but that did not help. Loaded it with latest version of firmware and did a re-bind with my Frsky Taranis X9D Plus and X8R receiver. There is power to all 4 of the 30 amp esc's, so the power module and the PCB should be ok. However, when it is armed, I have no power to the motor side of the esc's.
Not sure how to troubleshoot it from here. Suggestions please???
Brought it with me on vacation to Colorado. Powered it up to re-calibrate the compass for the new location, and the HK Quanum 2D gimbal did its usual flopping around (camera wasn't installed) and suddenly the gimbal stopped moving.
Now I am unable to spin up the motors. Everything else seems to work, and I get the armed sound. Have GPS lock. Mission Planner shows it as armed with a correct map location. But, motors will not spin up. Disabled pre-arm check in MP, but that did not help. Loaded it with latest version of firmware and did a re-bind with my Frsky Taranis X9D Plus and X8R receiver. There is power to all 4 of the 30 amp esc's, so the power module and the PCB should be ok. However, when it is armed, I have no power to the motor side of the esc's.
Not sure how to troubleshoot it from here. Suggestions please???