I have the new S800 Secraft SE retracts with the Hitec HS-7954 SH servos.
When I power on my S800 the retracts jumps back and forth until they strabilises in down position. This is occasionally.
I have tryed with BEC and without BEC (direct from RX).
Retracts do this even when they are only connected to the BEC and not connected to the RX
I use an Spektrum DX18 TX and AR9020 DSMX/XPlus RX. Endpoint set to 150 (down) and 80 (up).
Are there any good suggestions for fixing?
I´m been looking to:
http://en.m.wikipedia.org/wiki/Snubber
or
http://en.m.wikipedia.org/wiki/Filter_capacitor
or
http://hobbyking.com/hobbyking/store/__8833__turnigy_receiver_controlled_switch_.html
or
manual swtich
or
?
When I power on my S800 the retracts jumps back and forth until they strabilises in down position. This is occasionally.
I have tryed with BEC and without BEC (direct from RX).
Retracts do this even when they are only connected to the BEC and not connected to the RX
I use an Spektrum DX18 TX and AR9020 DSMX/XPlus RX. Endpoint set to 150 (down) and 80 (up).
Are there any good suggestions for fixing?
I´m been looking to:
http://en.m.wikipedia.org/wiki/Snubber
or
http://en.m.wikipedia.org/wiki/Filter_capacitor
or
http://hobbyking.com/hobbyking/store/__8833__turnigy_receiver_controlled_switch_.html
or
manual swtich
or
?