MadMonkey
Bane of G10
I'm repairing the landing gear on a large X8 and have a new set of Foxtech Pivots to install. The builder had the retracts plugged directly into the receiver, which I DON'T like.
What's the preferred method? The retracts have typical receiver plugs on them; I'm assuming I should solder a BEC into my PDB (5v?) but I'm not sure how to run the wiring. I could use a diagram... soldering is no problem but electronics aren't my strong suit :upset:
What's the preferred method? The retracts have typical receiver plugs on them; I'm assuming I should solder a BEC into my PDB (5v?) but I'm not sure how to run the wiring. I could use a diagram... soldering is no problem but electronics aren't my strong suit :upset: