[FONT=arial, helvetica, sans-serif]
[/FONT]
A- get these errores
1-CFG-ERR -Re-calibrate your transmitter,and power cycle your controller and check all of the parametersConfiguration error, this may cause by firmware upgrade from old version.or abnormal Tx calibration
B - X1-ERR / X2-ERR / X3-ERR 1.Power on the Tx.
2.Connect the X1/X2/X3 channel;
3.Disable all knob tuning.You’ve chose parameters tuning by X1/X2/X3 channel with Tx Knob, but no signal detected on X1/X2/X3 input channel,or Tx didn’t powered on.
C- SN-ERR Please contact with DJI support
D- PMU-ERR Please make sure the integrated connection among battery, MC and PMU. PMU connection problem.
F- RX-ERR Please check the receiver connection Connection between receiver and main controller is abnormal.
[/FONT]
A- get these errores
1-CFG-ERR -Re-calibrate your transmitter,and power cycle your controller and check all of the parametersConfiguration error, this may cause by firmware upgrade from old version.or abnormal Tx calibration
B - X1-ERR / X2-ERR / X3-ERR 1.Power on the Tx.
2.Connect the X1/X2/X3 channel;
3.Disable all knob tuning.You’ve chose parameters tuning by X1/X2/X3 channel with Tx Knob, but no signal detected on X1/X2/X3 input channel,or Tx didn’t powered on.
C- SN-ERR Please contact with DJI support
D- PMU-ERR Please make sure the integrated connection among battery, MC and PMU. PMU connection problem.
F- RX-ERR Please check the receiver connection Connection between receiver and main controller is abnormal.