Total Newbie: I have Hyperion 3S/ 11.1V 5400mAh batteries along with a Hyperion AC/DC EOS0600iAD-C Charger. I read through the user manual and followed everything for the setup, the only thing I was not sure about was the Amp's to charge at so I started on the low side around 2.1A. Anyway, It is connected through a harness to the charger. After set up I press Start...it searches and says " Bettery Check, please wait" then a few secs later says no battery connected...
Any tips or pointers on where I am going wrong?
Any tips or pointers on where I am going wrong?