vinito
Member
... and no, my name isn't "howdy", I was just sayin'...
Hi.
I'm from Kansas City and I just got done building a quadcopter.
S500 frame
APM 2.6 controller w/ NEO-6M GPS & compass
power module
3DR radio telemetry kit
30A "simon series" ESCs (apparently blheli firmware and not simonk)
Tarot 2814/700kv motors
5000mah battery (so far)
here's a quick pic of it as of last night:
I'll have some questions on the thing but I'll post those in a more suitable category.
I used to be into RC planes back in the '80s and have been out of it for a very long time. I picked up a Hubsan and then a Syma with the camera and have had a lot of fun playing around with them. Enough fun that I've got the RC bug again, but this time I'm liking the multirotors.
Not much else to say I guess. I'm a machinist so I make stuff all day long. I guess I never get enough of it or sumthin'. I piddle with electronics and been working on getting a 3D printer going for a while... it's almost there I think.
Hi.
I'm from Kansas City and I just got done building a quadcopter.
S500 frame
APM 2.6 controller w/ NEO-6M GPS & compass
power module
3DR radio telemetry kit
30A "simon series" ESCs (apparently blheli firmware and not simonk)
Tarot 2814/700kv motors
5000mah battery (so far)
here's a quick pic of it as of last night:
I'll have some questions on the thing but I'll post those in a more suitable category.
I used to be into RC planes back in the '80s and have been out of it for a very long time. I picked up a Hubsan and then a Syma with the camera and have had a lot of fun playing around with them. Enough fun that I've got the RC bug again, but this time I'm liking the multirotors.
Not much else to say I guess. I'm a machinist so I make stuff all day long. I guess I never get enough of it or sumthin'. I piddle with electronics and been working on getting a 3D printer going for a while... it's almost there I think.