Hi folks. Hope someone can help.
NAZA-M 450 with graupner 9" props... etc.
I set up the new firmware and double checked everything to see if the setting from my V1 got carried over...
I go to the yard and everything seemed fine but... after I waited for the warm up process... I tried a hover and all was fine about 2-3 feet up and it just dropped.
I powered down and waited again for the warm up and all is fine now so I did some forward flight and all is good.
I decided to try out my new 4S Pulse 3300Mah 35C and when I spooled up with the new take off mode the thing went straight up like a rocket!!!
I hit the power off and it landed in front of me. One prop broke... soft grass.
I did not have the voltage VU turned on in the software so there was no way for the NAZA to detect it I guess... but I did have the wire connected.
The only thing I can think of is the new firmware enabled the voltage monitoring but I doubt it.
Anyone?
Flies great on my 3S batteries.
THANKS
NAZA-M 450 with graupner 9" props... etc.
I set up the new firmware and double checked everything to see if the setting from my V1 got carried over...
I go to the yard and everything seemed fine but... after I waited for the warm up process... I tried a hover and all was fine about 2-3 feet up and it just dropped.
I powered down and waited again for the warm up and all is fine now so I did some forward flight and all is good.
I decided to try out my new 4S Pulse 3300Mah 35C and when I spooled up with the new take off mode the thing went straight up like a rocket!!!
I hit the power off and it landed in front of me. One prop broke... soft grass.
I did not have the voltage VU turned on in the software so there was no way for the NAZA to detect it I guess... but I did have the wire connected.
The only thing I can think of is the new firmware enabled the voltage monitoring but I doubt it.
Anyone?
Flies great on my 3S batteries.
THANKS