Search results

So, I have a Naza V2 flight controller and I bought a Mini OSD controller. I hooked it all up and there was no output of OSD data. So I did an RMA but to save time I bought another one. Guess what, same thing! So I sent it back, and DJI returned after 3 months, both of them under warantee...

Has anyone seen this? I have the range video 40A opto esc's (they are xztw spider esc's that use bullet connectors) and I have had issues with the bullet connectors separating from the circuit board. Its as if the circuit board is multilayer, but 1/2 the thickness of the board just comes apart...

Ok, How difficult can this be? You have video in, and video out. First my electronics experience....my last big trouble shooting exercise was board level troubleshooting using a scope and schematic on a 20 vacuum tube amateur radio transceiver to locate two failed ceramic capacitors....so I...

Ok, Everything has been going just fine with my quad in testing and shorter flights. However yesterday, I added my gimbal, and went for a real flight. Everything worked well, I tested failsafe, came back to home position perfectly. I sent it on it's way again and all was doing fine then all...

Hi I don't seem to be able to make any sense out of the naza gains. There are two sets of gains. The general, and the atti. I have yet to see an explanation about the difference. Why two sets? Which do you do first? What do you do if there is a wobble at default gain settings? Try as I may, I...

Hi, I have a problem which occurs roughly 50% of the time or more. When I power on my quad, and then link my transmitter (after waiting for led lights to be appropriate), when I arm the quad (both sticks to lower left) it may or may not start the motors. This happens about 1 in two or...

Hi, Is it normal that when I arm my NAZA M, it starts at around 50% throttle and then only goes higher as you move the throttle stick over 50%? Then when you lower it below 50%, the throttle doesn't change until you get to zero and then after three seconds it shuts off? I come from an...

Hi, Starting my build, but I was wonderin what the little colored washers are included in the Tarot 650 kit? Are they for mounting the aluminum standoffs in a different hole? Thanks!