Search results

I have a DJI NAZA V2 GPS on my 680. Have been using IOS for some time without issue. While flying yesterday "home lock" stopped working. Checked updates all good. Everything else normal and aircraft performs as expected in GPS mode. Tried again this morning with same results. Flashing grn on GPS...

Merry Christmas from 75 degree wet.... Slidell,Louisiana.

While I'm at it.. Advice on setting first and second battery alerts? 4s packs 25c 4500 x2 flight configuration.

Thanks guys. Pretty sure I found the problem... TAROT instructions (which I was following) show motor location and number one way. NAZA M V2 (which I should have been following) has the motors in a different order. Re connected in the correct order. Now aircraft sounds better already. Will...

Hi all.. Got my 680pro together. Has NAZA M V2, performed required updates and calibrations.. good GPS lock.. started fine.. upon initial throttle up to get in the air.. FLIPPED right over. Ideas? Butch

Hi all.. Got my 680pro together. performed required updates and calibrations.. good GPS lock.. started fine.. upon initial throttle up to get in the air.. FLIPPED right over. Ideas? Butch

Thanks

Here we go again.... Followed some "you tube" directions on setting up t10j.. Now same as before. No idea what I changed

Hello all I am building a TAROT 680pro.. ( I have been flying a Phantom 2 vision for 15 months and been into RC for 20+ yrs) first aircraft build though... NAZA V2 is installed in airframe, really all together. Radio installed also. NAZA asst. is on PC, Updates done. NAZA plugged in and...

Not sure that was an "argument" looks like a "statement" to me

........

Operator error as is the usual problem... Thanks all who responded

Yes low voltage was to high. But someone here has got to know about setting up a futaba t10j. Have GPS lock radio calibrated in NAZA assistant.. Mode switch set.. No radio control at all nothing pls help

it has to be a setting of some kind. The battery was low, flight system works fine now, GPS lock. in assistant all motors test good. receiver is bound to trans and woking fine on a spare servo i have. Just no joy on control of aircraft. nothing. thanks Butch

Thanks guys and gal. DJI is NO help.. Yes it is connected through the assistant software. Motors spin up in the software correctly. Now when i plug in battery i get "redyellowgreen,redyellowgreen...then four greens then flashing red..... DJI told me today that they "cant help me" thanks Butch

Hey all. Getting my 680 built finally. NAZA M V2, futaba 10j, etc etc. when I turn radio and aircraft on .. No switch just plug in battery. Get red/amber then four green then goes to fast amber flash. Says no TX? Nothing else please help Butch