Search results

Will a gopro 3+ black work on this gimbal DJI H4-3D

I have a naza m v2 and DYS 40 amp opto simon K on my octocopter I calibrated each ESC seperatly and they all started up. then soldered all the wires to a power dist board. I did a motor test and all motors were turning the correct direction. When I go to start the motors they will not...

I am going to build a big Octocopter with 4114 320 kv motors with a 6S battery I was wondering what size wire I should use for the motors to ESC. Also what size power distribution board? Any suggestions welcome. Thanks Mark

What does opto mean when describing ESC's? What is the benefit?

I hovered my hex copter yesterday and after about 20 seconds in the air it would glitch. The copter would pitch forward and backwards about 15 degrees then it would hover nice and stable for about 30 seconds, then it would do it again. During the flight the green lights were flashing the whole...

I have a mini osd and was wondering how to set up the wiring. my question is were do I hook the video in camera ground? attached is a diagram.

Can anyone tell me if it is ok to use XT60 conectors on 4s 4000 ma battery, or 4s 5000ma. I noticed that the batteries less than 3000 ma use XT60 but if you get anything higher than 3000 ma they use the big red connectors from hobby king. Thanks Mark

I have a Naza m V2 flight controler an was wondering what other electronics I would need to be able to fly to waypoints? Thanks Mark

Does anyone know about the low-voltage protection with the Naza m v2 what should I set the No Load voltage value to? And the Loss Voltage value? I am using a 4S 3000ma 20C battery

I am building a hex copter using a naza V2 flight control How can I hook up the LED lights. I have the led strips from hobby king but they run on 12v my copter is a 4S 14.8V If it were 3S I could hook to the balance port of battery. I have a power distribution board for my 6 motors with...

I am building a hex copter from hobby king with the following components: Multiwii Pro Flight control w/MTK GPS Afro 20a ESC (Simon K) NTM 28-36 motor Futaba 8 ch radio Power distribution board My first question is how do I calibrate the ESC? Do I have to calibrate them seperetly? or can I...

Does the flight control board control the direction of the motors? or do I have to reverse the wires going to the motor? flight control board is the MultiWii pro with mtk3329 gps module from hobby king.