mspaterick
Member
I have a naza m v2 and DYS 40 amp opto simon K on my octocopter
I calibrated each ESC seperatly and they all started up. then soldered all the wires to a power dist board.
I did a motor test and all motors were turning the correct direction.
When I go to start the motors they will not start up. every thing else seams to work correctly. Can anyone tell me whats wrong?
Can I recalibrate all 8 esc at one time?
Do I have to remove the power wire on all but one ESC?
I calibrated each ESC seperatly and they all started up. then soldered all the wires to a power dist board.
I did a motor test and all motors were turning the correct direction.
When I go to start the motors they will not start up. every thing else seams to work correctly. Can anyone tell me whats wrong?
Can I recalibrate all 8 esc at one time?
Do I have to remove the power wire on all but one ESC?