Search results

bernd, you have..... i think if your cutting into the prop that hard, it is over tightening. when you use graupner adapters made for these, it has a domed washer that goes over all that

try his ipower series. The bearings go from what i hear, but he sells em too and there serviceable. T-motors do the same....... i really like suppo,,,,,, but i'm getting ready to test a new one coming to MR market soon.... if you have 4s, use 10" props and the 760kv,,,,,, you'd be pretty...

other than stretching the wires to take em out, theres no difference if it's all soldered. alot less work to just solder it the way it sits. Clamp the motor wire to the arm and wet it out........ take 5 minutes to do em all. Those dji motors got a cover over the insulated wire. The actual wire...

wait till you hear em........ when i fpv in the right wind, i can hear em a 1/4 mile away. wicked earplugs on your cam, everything else won't care about a motor vibe unless theres a problem with a motor as long as the prop is left alone, not balanced and in tact. I get gravel burn from all that...

if you took and held the motor wire before the bullet and made that steady with the esc, took solder and just make the bullet wet, it'll reheat the other joints on either side and should give you what your after, but, if you change motors you'll want to proceed cautiously to not get it too...

the problem up there is thats on threads and cant get totally perfectly in the middle like a washer with a hole 8.02mm slides onto a 8mm shaft. honestly, if that kinda vibe is making a problem with something, dampen the something cause it's not much if any different.

the failsafe being stored in the rx happens on all of em, it's how when it looses talks with the tx it knows what to do. futaba, jr, spektrum, ezuhf, dragonlink, rangelink, they all have it like that, but each of em has a different way to write it to the rx. spektrum/jr is the worst with the...

The new fatsharks are out...... predator v2 and attitude models http://www.readymaderc.com/store/index.php?main_page=product_info&cPath=11_22&products_id=1128 http://www.readymaderc.com/store/index.php?main_page=product_info&cPath=11_22&products_id=1129

if a receiver has programeable failsafes, you just remove the bind plug after booting the rx, but before booting the tx during binding if it's programeable throttle only, i'd look at what happens to the flight mode after setting up the model but while inside assistant. For all i know the center...

mine did but not after i rebooted after he updated the forum..... what happens then, cookies deleted or cache purged,,,, something like that might try tools/clear recent history

there is a servo refresh rate setting that's 400, 200, something and 50

ear plugs fix jello, graupners make your rig happy and fly right

you guys want M6 locknuts, never have to over tighten to get to stay, i believe it also goes down far enough to get rid of your washers under the props....... hardware store, depot, lowes, etc. i got a bag of em from mcmaster carr

on a dji esc, the wires that normally go out to the motor are bullets that have a cut in them and there slid onto the pcb with silver solder. so a couple things happen, you can easily cause a short without solder skills.you get the esc's pcb hot getting it apart. The problem tends to be on the...