Search results

hahaha

polar pro....http://www.polarprofilters.com/products-page/gopro-filters-standard/goprofilter/

were gonna plan trips all over to different spots so it'll be fun and for me easy and close. The desert i fly at is an hour twenty and about $80 in gas. the river is 3 hours away and about $145

Oddly enough we all got along so well and have so much in common we've formed a flying group. Going one step further the guy that organized the event has taken the Video Pilots Association under his wing and were gonna work on building it up. Was something guys at fpvlabs started a long time ago...

that's a good friend of mine Dditch with the big water bottles, won the HK thing I've been around the xlc a bit. Things a beast, looks like the size of a snow mobile walking up to it

if you light a fire in an oven, depending how big it may or may not contain it..... you kinda leave the whole 450 degree like an oven and hit the whole thousand degrees like a fire with a fuel source...... we had a seminar by our fire dept on how to put out a lipo, the only way was smothering...

very nice soon we'll get a shot at em

if it replaced a hd recording cam then it would be fine, but the stuff i use is like 20 grams..... bare board cams are what most fpv guy use........ no recording, no cases just a really high quality camera to fly through...... WDR are super important, being able to look at the sun and see the...

things like 5 gallon bucket full of sand with lid are common place at ama fields...... it's how you want to transport a lipo that got hot. to charge you should use a lipo charging bag and most people utilize concrete, brick or some other un burnable material to set them on. That ammo can...

it's a weight to lift thing as far as what you match up. in naza we try to make it hover at half stick in manual once were actually flying and worrying about making it fly better. 3s uses larger props, 4s smaller props. small props do good in wind, but big props carry loads better, again its a...

it's not? I'm so confused trying to figure out what that is

get yourself some apc props to start off with http://gothelirc.com/shopdisplayproducts.asp?id=117&cat=APC+Props

I have 40c packs and draw 60 amps so i'm a little different probably, but i hit the ground at 14.1-14.3 and when i kill the motors, it's 14.7-14.8... it's voltage sag and every pack handles a load different. That's why this part of naza sucks IMO. It put me on the ground twice. it's a better...

lens looks good. not too much fisheye, colors are bright, sun washes it out a little, but the lens looks expensive moving around in the light...... compared to gopro. I think it'll make a fine fpv cam it has this weird slo mo mode.... when you play back 120 fps you have to do it x4 speed to...

couple more,,,,, got new prop adapters coming, hopefully they will clean this up. I'm running a bunch of crashed parts right now.....

that link i have above is to the combos, cased and not....

this cam seems a lot lighter than go pro can go anywhere you don't get the craft in view...... idealy you want it on the camera tray but...... yea, i love that cam, i just ordered a 3.6mm to try. Should help my sore old eyes pick stuff up better than the 2.1 and 2.8...... think the better i...

before i whacked anything was trying it like this. but i think i want to slit the top frame to slide this straight down, or at least lower than this

the waterproof case has the 1/4 20 hole and the little pin hole,,,,, but the cam by itself is blank, like a cell phone with a came on top and you gotta do something with all that. tim nilsons rig from fpvmanuals.com,,,,, getfpv.com.... but he gets jello

making sure it's on lipo mode,,,,,, your amp in is the mah divided by 1000 so your good to 5.4 amps, that is 1c rate. You have to connect the little harness and the big wires to the charger..... that will balance charge it.... if just the main big wire plug is used, that is a fast charge or...