Search results

wonder if battery type (C rating) has to do with it? what battery specs are you using? I am using 6S 65C batteries and have no issues, .. but when I tried the 6S 30C, I did notice the Zenmuse sometimes not calibrating.. about 3 out of 7 times it would give me issues. On my 65C batteries, it...

what battery are you using at 22000mah? how much does it weight? I would like to get 22000mah, but can't seem to find the right weight to get 22000mah. KS

@ redridinghood, Any videos of it in action? I am wanting to put on together.. Can you help suggest motor, esc, battery and props? KS

Has anyone mounted a Zenmuse on a Skyjib? I could not find any reference nor found any one on the web doing it. If you have, can you share how you mounted the Zenmuse? Regards, KS

@ Chris, I have to check, but I am sure I had to use traditional from RX to WKM and ZEN15. I remember, but need to verify, that if I used S-BUS, both the WKM and the Zen controller wanted to be on the lower channels. I did not spend much time.. just thought I would get it working to start...

Chris, in that video, I use the WTR-7 trainer. That WTR-7 is paired to the 2nd man TX. Then it is plugged into the 1st TX. I then share the Zenmuse channel to the trainee (2nd TX). You can flip off to take control back from the trainee (camera operator) at will or share it. I don't have a...

@ Gadget, I have the old GPS.. was yours? KS

Man I am interested.. I need to get rid of one of my S800 frame to get this... unless you are up to trading? KS

so, I just upgrade from 5.14a to 5.14. the s800 seems to be all over.. randomly actiing as if the GPS is not aligned with the magnetic course. Spent several ours hovering a low altitude trying to adjust gains. Still at best, my yaw/tilt/roll is at 220.. it still swirls around when I let the...

@ yeehaanow, That was what I was about to ask too? KS

got it... will try that. last night I balanced all the props. normally flies pretty well till recently (last 4 weeks). I guess the gains changes around? Thanks for the suggestions. KS

just when I was thinking up going from my 5.14a to 5.14..:( my 5.14a is staring to behave weird. flying 6 flights with no physical adjustments and no software gains change, all 6 flights seems like the gains are like a moving target. 1 flight would act as if the gains were low.. slow and...

where are you?

I am noticing that my craft is changing it's response little by little. I fly with 2 6000 6s2p. 3 sets.. all have same life on them.. I always charge to 4.1 per cell. without any changes to the S800/Zen and the WKM.. (been like 2 months) since I plugged the WKM into my laptop. I always...

got it.. after I posted and took a break.. came back and decided to heat the screw on the bottom side of the arm.. then I slowly broke loose. damn.. almost 45mins on 1 screw... glad it is off though. Crazy!!!

Why is that, every 5-10 screws is stuck on the S800 frame? I am trying to unscrew the motor to check the ESC solder job on my S800. 1 arms goes by fine, second arms has 1 screw that is hard to unscrew.. I put my solder tip on the screw and it finally comes off. I am on the third arm, and 1...

In this specific setup, the pilot TX is the T8FG Super. The receiver is the R6014HS. I am not using the SBUS on this setup. My other S800 using same TX, but the 6208SB with SBUS. Though keep in mind, the 6208SB only has 1 SBUS port that goes to the WKM Controller. The WKM does not allow...

were are you located? do you still have it? Put me in line too.

depends on what you want to control.. 14 channel works great if you have the Zen and want to do 1 man. http://youtu.be/daEoQs1_jvo Here is my setup that allows both 1man and 1man setup on the fly. KS

what the hell..:) got "rick rolled"..:)