Search results

Thx Old Man, I did move Gps higher & far backward 10cm above rear boom arm

Im using KDE 5215 330kv, KDE 55a esc, 6s, super X, 22inch wood prop and 20inch CF mark II. I got those props from fox tech. stable in high winds. Wood props perform better for heavy load

I 've experience 1 esc burn during flight with Super X. Medium Y6 config. 1 esc short circuit also burn 1 motor, lot of smoke no effect in stability during flight, no panic, landing safely. I believe it will do the same with X8. Make sure you are flying with below 65% of thrust

5.20

all futaba radios need everything reversed for superX, do you mean reversed chanel 1-4? Can you share more detail about G set to 20%? Any step by step to follow(link)? Just bought a Futaba 14SG. My hitech aurora 9 didn't sync with KDE esc and KDE 5215 Many thanks, Ary

Tmotor 4014

It's not 100% done. I will use 2X 10000mah. Battery position on top of center plate, too keep good vertical COG

8108 pan, 5208 tilt & roll

Vulcan with longest arm & motor mount for Tiger U8. 3mm cF centre plate. I kept it simple and strigt forward layout to achieve better power to weight ratio & longer flight time

Will do soon without sound

All ESC inside center plate

AUW 15-18kg. Still testing. Im using Super X. It's better than my wkm in windy condition I need a heavy lifter with smaller footprint. expecialy when shooting in remote location. This setup will solved my problem

My new build a Tripcopter/Y6 with 22 inch props Here's some pictures.. Spec : KDE 5215 330kv, 22X7 inch wood props, Super X Smaller footprint compare to X8 and still manage to lift 15 kg with 50% throttle

Thx to KDE (Patrick & team), they are respons quick and fully aware about the problem & will find a solution (including with Xaircraft rep.) Two thumbs up !! Well DJI how about that

Great shot

No luck, tried to recalibrate remote, etc.. Last move: swap Super X with WKM, we''ll see... Ary

I have other KDE ESC instaled on other rig without problem, I did 1 time throtle calibration and work perfectly. Combos are: WKM, KDE 35 A ESC, Tiger MN4014 kv330, 17X5.8 Tiger CF prop, Hitec Aurora 9(picture attached). I will try to recalibrate super X throttle as Kloner suggest(finger cross)...

I have sync problem between KDE esc and Super X controller. I've tried normal mode and pmw mode on superX software. With normal mode I'm only able to sync/start up 3 motor. Im building hexa with Y6 configuration Hexa set up : SuperX, KDE 5215 330kv, KDE 55A ESC, Hitec Aurora 9(tx/rx) Does...

Im using KDE 35A ESC on my X8. WKM, MN 4014 kv 330, Tmotor Props 17x5.8. Esc respons faster than my old 400mhz simonk esc Ary

I replaced my old 400mhz esc on X8 with KDE 35AESC. Faster respons... less oscilating. Solid performance My X8 config: MN 4014(330kv), Tmotor 17x5.8, WKM, 1000mm frame Ary