I'd like to replace the cover on my puck. It has a couple of nicks in it that drive me mad.
Does anyone has a dead puck they wouldn't mind parting with the cover or know of an avenue to get one from DJI?
I've got the AMP HL Kit (arm extensions + AMP 2814s) and running the Graupner 11x5. I've never run a different prop with the HL kit. But they run well.
For sake of troubleshooting I'll walk through the process I use.
I disconnect all the servo leads from the WKM FC. I take the RX sbus lead going into X2 and plug it into throttle channel on the FC. I take the 4-1 harness and plug it into the throttle port on the Futaba R6208SB take ESCs for...
Here is an issue in have with newly installed ESC 's. M1 M3 and M5 are new ESC but they are the exact same model from AMP. I've patched the ESC from M2 to M1 and M1 then spins up just like the others running right.
What's going on here ?
I am pretty new at soldering. I don't think that's the...
I was digging through old forums that I came across this thread:
http://www.multirotorforums.com/showthread.php?12716-Throttle-Calibrating-my-Esc-s-Caused-Unwanted-Changes
I read that you set your throttle to -120% before in your TX before calibration then back to 100% afterwards...
I had a crash this past week and all the parts are in and tonight I'm going to put my platform back together again. I got lucky and only need to install a new ESC and two motor extension plates.
Can any wisdom be imparted on things I especially need to do either for my FC or otherwise before...
I've got a MaxAmps 4S 9000 mAh 100C that I get 8 minutes with and a MaxAmps 4S 11000 mAh 40C that I get about 13 minutes out of when it's fully loaded.
Scott, why take off the zeal tape from the FC. Just to see if you'd balanced properly or is it not good long terms to have the tape under the FC
Here is my set up. Nothing jumps out at anyone?
It'll fly fine and then begin to "buzz" and jump in elevation. It will stop freaking out and I'll regain control and being to back to earth. Then out of the blue it'll shoot up again.
A theory that my flying buddy and I came up with after the second insistence of the same issue is that an...
It happened again! This time a bit more violent. At the end of the flight there was a crash landing
But this time I lost M5 during the flight and upon inspection after one of the ESC cable had come unsoldered from the ESC. I'm confident that this wasn't a result of the crash due to the...
A buddy and I were flying this evening and he was testing out some minor tweaks we had changed. I flew through a battery with no issues. I had been having GPS issues that after our tests were seemingly resolved.
We swapped lipos, recalibrated compass, acquired 9+ sats and he took off. It...