Recent content by edgarmillennium

Hello: Recently after few flying shots taken with the 3h-3d it started a Yaw glitch. I called the distributor and he told me to do the upgrade, I did it and was gone during some flights. It happened again. This time I called DJI and they told me to do the upgrade and avoid to have the gimball...

When I first designed my hex , it was with 12" props 690Kv and 4s batts. It is s F550 with the aluminum arms. I had very bad stabilty issues due that it was over power. The DJi are set to hover when control is at 50%, so when I hit %50 on the radio it still wanted to go up. So the Controller...

When you use more voltage, you need less amp to get the same watts. So with 4s will get more flight time and more RPMS also for the same amps. You probably can switch between, but you will have some trouble gettign use to each pack. Also if you have Naza and activate the voltage monitor you can...

The break practically does that. It brake the motor when is close to stops. Istead of reducing rpms by itself the motor, the esc brakes it. The controller I reger to the Naza lite. I had the naza lite before. I had thatvproblem and found that in my case my setup with 12 was over power and the...

You need to be sure it does not have brake activated. Also what controller do you have?

First, did you turned off IOC at the Naza software??? If you haven't you are still activating the IOC at the control. Because is receiving signal trought the new knob. Are you getting green light when in GPS mode?? If yes you are ok to flight.

Ftundra. I did not said that it will tell the exact statis of the batery. I just a guide to determine how stressed can be the battery with improper draining due to measuring the voltage wrong. My post is specific related to the temp. And for sure you know that when you lower too much the battery...

Hello: I have installed a ImmersionRC 5.8 600mw system. With the antennas that look like nails with big heads. But sometimes i have some glitch that I loose the signal for less than a second, but it comes back immediately. My issue is that if I want to have live feed, will see these glitch. Are...

In my case the get about 110*F just at landing. which is not bad. About the voltage, the best way to know how the ending voltage is with the IOSD or a meter connected to the balance port. Sometimes we tend to measure the voltage after few seconds of stopping the usage. I found a difference of...

I think you just responded your self what is the problem. You are not charging completly the batteries. A simple solution is to put another charge cycle on them. But it will not always work that way. You need to get a better charger for those lipos.

Do you mean that it have a top limit of 6000 or that it can charge up to 6amps?

My hex have about the same gains 180 on basic. If you loose altitude during yaw, probably is under power, you need to increase gain. If it jumps when stick Is release during yaw, then I high gain.

Probably you will want to look for more than 8 channels, right now I am using 7 channels; basic 4 Flight mode 1, IOC 1, pitch control 1. So if you have a 3axis gimbals, probably you will want to control more axis on the gimbals

There should be something wrong there, when you charged them back, how much miliamp they took?? the 10k??? I just charged mine and is a 8000 and it charged 8600. It was droop until 13v loaded.

Theorically every time you make a change on receiver, tx or esc, you shoudl calibrate them, no matter if they are the same brand. Not all radios, RX and esc response the same way. You need to verify if the esc indeed calibrate. Some don't need it.