Great,
I've been making some drawings for an Y6 frame too. Mine is going to be built in aluminium. I'm not sure about the final diameter. For now, it is about 52 cm (450 mm between axes). But I think that the arms are too short and at the end I shall make it with longer arms. It will be nice to...
I would like to state that I don’t have any relation to the cited company. My intention was just to mention a simple fact that I found to be interesting. And I think that my post is in line with many others that make this forum so friendly. Your comments seem to be an exception (coming from an...
Yes, I was surprised to see a long article on this subject, on portuguese TV evening news at SIC.
I could post you the link, but the video is in portuguese, you probably wouldn't want to look.
But the models were very interesting, and made in Portugal. By UA vision.
And I was surprised by an...
Thanks for the advices. you are most certainly right. And I'll take in consideration your comments.
By the way, I liket your craft. The only thing I would change is the dome. I think it would be worthy to build some fiber glass protection wirth a more elegant design.
I will send you my mail and...
Hi Sportcam,
I wouldn't dare to "copy" such a complicated frame. I know that it would me less expensive to buy it than to waist meterials and time to try do reproduce it.
What I meant was to buil my version in that style. This means to do something with a core with similar volumes and geometry...
Hi Ovdt,
I would be grateful if you can find me something.
I own a xaircraft x650. But the load limit is low and I don't feel confortable to use it with all the stuff that I plan to install sooner or later. I installed several lights, and with the harness and switches and a reinforced landing...
From the frames I have seen, the Q4 Y6 is the one that impresses me the most.
so I would like to build my diy version similar to this frame.
But the only informations I can get are the usual pictures available on the related sites.
Anyone could give me some more details? a building manual or...
Hi,
I own the old version x650c. I want to connect some 5v lights, using the integrated ubec function of the ESC-A4. But I have no idea of where I must connect wires to take the 5v corrent out.
Anyone can give me a hint?
Thanks a lot
C.Monteiro
Hi,
Is there any device that could solve me this problem?
I have a ubec that supplies a 5v current.
And I have a rc operated switch for commanding the 5v lights.
But now I want to add a 12v led. So, I can’t connect it to the rc switch.
I would need something like a relay, that would be triggered...
I also would be very interest to know detaisl of your setup. But you are right. I bought me a xaircraft x650 because I didn't have money for more. And bought it because I'm new to all this and didn't have the experience to build a craft combining several brands and solutions. But that is my...
Hi guys,
I am doing some experiments with my x650 and gps. I am trying several positions for the antenna and reading the Pacc value on the software xaircraft center.
And the best values I get are over 200 cm with 6, sometimes 7 satellites.
You probably have already read the gps parameters on...