Recent content by Cloud Level Media

copy that Aero. 4.02 on CC ESC's Not for the HF sport board. I guess I will have to swap the ESC's to the HFP and see if I can get it to work there.

Having some issues getting the HF sport to run with these ESC's CC Phoenix 35 HF sport. I have reflashed with 4.02 firmware and set parameters per HF recommendations. Done Throttle endpoints. ESC's beep once then just keep flashing. Anyone had success with these ESC's? cheers Mike

yes that is how to program the trottle endpoints but I need to calibrate them for HF FCs with these paramaters. Parameter Setting Brake...

Anyone tried these yet? http://team-blacksheep.com/products/prod:30aesc If so how would one calibrate them for use with HF Sport? Programing card? Cheers Mike

Castles are really nice! Pricy but I think it's worth it. They run SO smooth. Once I have the coin I will be converting my Octo and Hex to CC.

Not sue if this is what I was experiencing last summer while fling in South America. I would power up and get the beeps you are talking about and it would not let me arm. After a few reboots I could arm but performance was quite bad and even had a full shutdown while in flight. Unexplained. I...

Cool. Are u guys having better results by removing the pots from the system and going with continuous rotation servo setup?

Gimbal Setup. I am having some issues with slight jerks on the roll axis using the HFG. 1.3 seemed ok. 1.7 I had roll coupling. Just updated to 1.8 and I am seeing the stepping. When I roll the copter quickly the gimbal is mostly smooth. when go slow (how I usualy fly) I get a steping or jitter...

My main rig flew great in the snow and light rain. I used a cloth bag to put over the FC. I wish I had a umbrella to use while setting up in some locations as rain and snow fall into everything while your getting ready. I wouldn't recommend flying in a downpour but I had no issues with heavy...

The frame is a prototype Cinestar 4 that I have built up. HFP CC Ice50's Pulso 2826/12 motors Gaui Crane3 Gimbal. Flys a NEX-5 Cheers Huck~

1.8 firmware fixed yaw coupling! Nice job HF! Unfortunately my roll is not as smooth as it was. I am geting a stepping sensation in the roll axis. What am I missing between updates? cheers Mike Hagadorn Cloud Level Media

Sorry boys I have been out of the loop on this. Also I have not been flying my 2 man octo as much lately either. I just took it out for a test flight after some recalibrations I did to the HF Gimbal board a few weeks back and I am still getting the Yaw\Roll coupling. I am flying. I yaw left...

Just got off the road from shooting this quick webisode series for Onthesnow.com I got the opportunity to travel with a quad for the tour. We got some nice shots throughout the trip. I just wish I had more time to fly. The schedule was really tight! There is a little bit of Heli in each...

yea its that thing! I crashed flying FPV a while back and one side of it broke loose. I resoldered on but its such a small point that I wasn't sure if i did a very good job. I did fly it yesteday for a moment. It armed flew fine. Landed unarmed the board and it started recycling on its own...

After a FPV crash a few weeks ago a small piece was loose on the HFP. I resoldered it on.. It is a small round can looking thing on the front right side of the board. I brought this little beater gopro only quad as a back up and for risky flights Just finished a shoot and after alot of...