What battery with this setup

[ChEB]

about to order a Tarot FY650 to carry my gopro 3 from helipad however I have no idea which battery to select. This is the part that makes me think im in over my head. I'm also hopping this setup will work? Was hopping for 5 to 10 mins of flight time. I'm guess that I need a 22.2v 5000mah 3S and if thats the case I could use some recommendations.

4 Storm AS-2216 motor (880kv)
10" carbon fiber props
DJI Nava-M V2 multirotor Gyro System w/gps
hobbywing 30A OPTO pro ESC
Walkera Devo RX701 2.4Ghz 7ch Receiver
Boscam 5.8 ghz FPV TS352 tx
sony 700TV lines CCD Camera
Tarot T-2D Brushless Gimbal

 

[Motopreserve]

I am pretty sure that 22.2v will be a 6S battery. Folks here like and have suggested the turnigy nano-tech brand. I went with those - 5000mah 35-70c 3s. They weigh just under 300 grams.

if you wanted the 22.2 volt you'd be looking at these:

http://hobbyking.com/hobbyking/store/__11937__turnigy_nano_tech_5000mah_6s_25_50c_lipo_pack.html

 

[jbrumberg]

Recommended Configuration 1: gopro configuration (recommended)
180-250W Motor +20 A ESC the +4 S 5000 battery +10-12 inch propeller
Recommended configuration: micro single configuration (generally recommended)
300-400W Motor +30 A ESC the +4 S 5000-10000 battery +12-14 inch propeller
Recommended configuration: SLR configuration (not recommended)
400W motor +40 A ESC +6 S 5000-10000 battery +14-17 inch propeller

I copied this from a thread pertaining to your model Tarot frame from rcgroups.com. Have you run your setup through eCalc?

 

[PeteDee]

On that frame and the weight you are planning those motors are only just powerful enough.

You will need a 30C 4S pack, 5,000mH would be a good size I think.

Pete

 

[ChEB]

Recommended Configuration 1: gopro configuration (recommended)
180-250W Motor +20 A ESC the +4 S 5000 battery +10-12 inch propeller
Recommended configuration: micro single configuration (generally recommended)
300-400W Motor +30 A ESC the +4 S 5000-10000 battery +12-14 inch propeller
Recommended configuration: SLR configuration (not recommended)
400W motor +40 A ESC +6 S 5000-10000 battery +14-17 inch propeller

I copied this from a thread pertaining to your model Tarot frame from rcgroups.com. Have you run your setup through eCalc?

haven't found an eCalc yet (working on a slow satellite internet connection until i get back home)

 

[ChEB]

On that frame and the weight you are planning those motors are only just powerful enough.

You will need a 30C 4S pack, 5,000mH would be a good size I think.

Pete

after continued research I agree. I'm now going with turnigy multistar 4822-690Kv motors and 12" props

 

[PeteDee]

haven't found an eCalc yet (working on a slow satellite internet connection until i get back home)

http://www.ecalc.ch/xcoptercalc.htm?ecalc&lang=en