Tiger ESC problem
- Thread starter paktazh
- Start date
Mojave
Member
Please be a bit more specific: name on ESC, new build or crashed, calibrated to throttle or not, etc. Then someone should step in when we have more info. thanks.
Tiger motor 30a advance ESC new build it does calibrate I thing but it does not start when it connect to my flight controller when i rais the throttle it beep slow only other wise if the throttle is down it does not beep
Jareth_Atian
Member
Are you using the T-Motor T30A Opto Pro or the T30A?
Also, can you be a bit more specific than 'it does calibrate I thing'?
I've not used T-Motor ESC's before, but a few minutes of googling found:
http://fpvmanuals-1997231222.us-east-1.elb.amazonaws.com/graphics/Tiger-ESC-Manual.pdf
On page 3, there's a section 'Powering up the ESC for the first time and setting the Automatic Throttle Calibration'. Is that what you did, for each ESC individually? If not, how did you perform the calibration?
Also, can you be a bit more specific than 'it does calibrate I thing'?
I've not used T-Motor ESC's before, but a few minutes of googling found:
http://fpvmanuals-1997231222.us-east-1.elb.amazonaws.com/graphics/Tiger-ESC-Manual.pdf
On page 3, there's a section 'Powering up the ESC for the first time and setting the Automatic Throttle Calibration'. Is that what you did, for each ESC individually? If not, how did you perform the calibration?
Last edited by a moderator:
This is the ESC but the 30A one and regarding the calibration i did them all at one and also individually i placed the throttle on the top then it was confirming my 4s lipo then when i bring the throttle down it does one beep and when i push the throttle up it start but when i connect the ESC to flight controller it does not start and if i push the throttle up it keep doing one slow beep
http://www.quadcopters.co.uk/t-motor-40a-esc-343-p.asp
If those are the esc's you're using, they're not opto's which means each esc is going to feed 5 volts to your rx. The naza has a vu (voltage unit) that supplies the rx its 5 volts already. Do a search on disabling your esc's bec for naza (usually involves disabling the red wire from your servo lead on all your esc's).