TBS Discovery Pro OSD

[billmac]

I am having problems with the built in OSD the display is scrolling across the screen but the picture from the camera is OK ( camera is a TBS 69 ).The picture supplied is the image that is displayed from the vtx port on the main frame of the quad.
Can anyone give assistance as I have been at it for days with no change, another thing is I cannot see the OSD menu or it is not working ?</SPAN>

 

[bruce365]

Not sure but have you checked that everything is set to either Pall or NTSC? regards - bruce

 

[PeteDee]

And that Bruce is what is usually the problem, if they are set correctly then you probably have a faulty Core, they are pretty much bulletproof so they either work if set up correctly or they are faulty.

 

[billmac]

Thanks guys have tried it in Pall and Ntsc without any success so if it is the core should I send it back to the store I got it from this would be major pain in the ***. Mind you the hole TBS thing has been a pain in the ***.</SPAN></SPAN>

 

[kloner]

that monitor should have several pal and ntsc modes, go through them all..... it's in the monitors setup screen. I've seen a similar look on a rig that had extreme hoping on the ezuhf enabled, that on by chance or dragonlink?

 

[billmac]

Hi Kloner
thanks for the reply however not sure what you mean(several pal and ntsc modes) I think its the core as I cannot see the OSD on the TBS69 its the Pro
so the core was already installed with the shield.

 

[PeteDee]

From that photo I can see the OSD is working, there is a mismatch on the sync though. You could just make up a lead and run the camera directly into the vTx to eliminate the Core and make sure everything else is working.

Pete