switching to manual mode

E

edykosta

Member
hey everyone im a little new to this so pardon ... i have the wookong m on a hex i bought it from someone else with the transmitter dx8 and everything already set. my 3 position switch has gps/atti/ch... im trying to calibrate the compass so i need to access manual mode. not sure on how make changes on the 3 position switch so i can have manual mode available so i can calibrate compass. using 5.12abeta
any help is appreciated Thanks !
 

kloner

kloner

Aerial DP
it should be an end point setting for something like gear channel, usually. there is a menu in your radio, see if any of those have been changed. usually ch 5 or 7 and it has to be adjusted while you have the mr connected to assistant. moving teh end point makes the bottom thing in tx cali move from man, atti,gps..... usually guys put them on a 3 way switch and it does all three
 


You must log in or register to reply here.
Top