I have checked the wiring about 7 times. Its just weird, This bird flew great for the past few weeks, no problems. Let her sit for a few days and BANG! I just un-installed the software and drivers and am re-installing. So far I have done the following:
1: re-bind the transmitter atleast 15 times
2: Changed the RX from a 6100 to a brand new spare 8000
3: checked each and every wire for damage etc......
4: Changed Computers
5: Changed USB Cords
6: Checked every setting and every screen on the TX
7: checked each RX by putting them on my TBS and re-binding - Each RX works fine
8: Download the firmware and updated numerous times. Interesting note: Firmware updates, blue light is on, system beeps during upgrade, software tells me to disconnect and reboot system, however blue light is still on! (Possible problem?)
9: I'm going balded!
10: When plugging battery to system, it beeps normally and then flashes red light, before I even connect the usb to computer. The second I plug the USB in it goes straight to CFG-ERR(8)
1: re-bind the transmitter atleast 15 times
2: Changed the RX from a 6100 to a brand new spare 8000
3: checked each and every wire for damage etc......
4: Changed Computers
5: Changed USB Cords
6: Checked every setting and every screen on the TX
7: checked each RX by putting them on my TBS and re-binding - Each RX works fine
8: Download the firmware and updated numerous times. Interesting note: Firmware updates, blue light is on, system beeps during upgrade, software tells me to disconnect and reboot system, however blue light is still on! (Possible problem?)
9: I'm going balded!
10: When plugging battery to system, it beeps normally and then flashes red light, before I even connect the usb to computer. The second I plug the USB in it goes straight to CFG-ERR(8)
Last edited by a moderator: