Hi,
I have a problem which occurs roughly 50% of the time or more. When I power on my quad, and then link my transmitter (after waiting for led lights to be appropriate), when I arm the quad (both sticks to lower left) it may or may not start the motors. This happens about 1 in two or sometimes more times.
If I power off and try again, it might work. Eventually it will work and then all seems OK.
When it doesn't work, the transmitter and receiver are linked, the Naza LED will flash appropriately when controls are centered and flash propery when not. Also, if I switch to failsafe, the LED will flash telling me it is in failsafe mode. So All seems to be working except the motor / esc setup.
Frame Tarot 650
NAZA M V2 FW 4.01
Radio FUTABA SG14 + F7008SB in sbus or normal mode makes no difference
Motors SunnySky X4108S 600kV
ESC's RangeVideo 40A Opto (with SIMON firmware).
4S battery. All voltages are correct from PMU, to ESC's etc.
Thanks, Tom
I have a problem which occurs roughly 50% of the time or more. When I power on my quad, and then link my transmitter (after waiting for led lights to be appropriate), when I arm the quad (both sticks to lower left) it may or may not start the motors. This happens about 1 in two or sometimes more times.
If I power off and try again, it might work. Eventually it will work and then all seems OK.
When it doesn't work, the transmitter and receiver are linked, the Naza LED will flash appropriately when controls are centered and flash propery when not. Also, if I switch to failsafe, the LED will flash telling me it is in failsafe mode. So All seems to be working except the motor / esc setup.
Frame Tarot 650
NAZA M V2 FW 4.01
Radio FUTABA SG14 + F7008SB in sbus or normal mode makes no difference
Motors SunnySky X4108S 600kV
ESC's RangeVideo 40A Opto (with SIMON firmware).
4S battery. All voltages are correct from PMU, to ESC's etc.
Thanks, Tom