Props

rwilabee

Member
I have been running 11 x 4.7 props on my quad. It appears that for 550mm size frames that quite a few are running 10 x 4.7. I wonder if there would be an advantage to running the 10 x 4.7 before I spend money on them.

Thanks
Rich
 

thepelell

Member
what's wrong with your current setup ?
it's not a question of what others are running, it depends on how your machine is flying.. mora than frame dimension, weight and hover throttle are more important.
if you are hovering at 40-50% and the quad is responding good and not sluggish , then i don't see why you would have to change props. If instead you hover at 40 or lower % then probably you can loose some thrust in order to have motors in their better range. I dont know if you are at 3s or 4s lipo, but with a 4s and 11" props and 885kv motors, you should have some very good thrust.
my 2c.
 

rwilabee

Member
I'm hovering just fine at 40 to 50% throttle, but what kind of height are you talking about. At 50% throttle I'm probably hovering at 30' in the air. Does that sound about right or are we talking a 5 foot hover at 50% throttle.
I'm running 3s lipos.

Thanks
Rich
 
Last edited by a moderator:

thepelell

Member
it doesn't matter at what height you hover, anything above 1m ( or 3 feet for you imperialists :) , and you manage to keep constant height is ok.
i no nothing about your motors.. usually with 11" props 4s lipos are used so the motors have more grunt and be more responsive... but every setup is different... i hated how 10" props and 3s lipo behaved with multiwii, but insteaad work well with FY91...
you just have to do some testing...
 

roycruse

Member
Slightly unrelated question but ive heard 550 and 330 sized frames mentioned a few times now. what exactly does this number refer to.

is it radius from the centre to the motor, or diameter, or motor separation distance???
 

thepelell

Member
it's the distance in mm between motor shaft of opposite motors, so its the diameter if the quad was an O instead of X
 

Top