i am setting up 3 way and override switches, I've got the" SE "switch set for the modes, I can get the offsets for atti and gps to land on the right spots, but for manual, i can get manual highlighted on the assistant but when I hit enter on the radio the highlight slides over to the right side of the screen and the offset goes to a GV1 reading, Its the same with the failsafe switch, I am using the "FS" switch, it does the same thing, get the highlight to land on failsafe, when I hit enter on the radio highlight slides to left and I get a GV1 reading for the offset. But the good part is that when I switch the failsafe switch on it does deactivate the mode switch, and the mode switch operates correctly, cause the naza led is giving me the right codes. green flashes for gps, amber flashes for atti, and no flash for manual. Sorry for long drawn out question, but any help would be appreciated, thanks